Your cart is empty.
Your cart is empty. Specifications:
Power supply: DC12-48V. spindle: 48V 0-500W
Applicable software: Grblcontrol (Candle), La-ser GRBL and other software supporting GRBL firmware, GRBL firmware version V1.1f.
USB interface communication, support three-axis engraving, las-er module.
Features:
3 Axis GRBL V1.1f 32-Bit Controller offers advanced control capabilities, dual Y-axis support, versatile compatibility, offline operation, and a wide range of applications. It is an essential component for those seeking precise and efficient control over their woodworking, CNC routing, or laser engraving machines.
Package include:
1pc 3 Axis Stepper Motor Drive Board
Note:
1. Actual color may vary slightly due to differences in monitor display for the color of the products.
2. Measured manually, there may be slight errors in dimensions
Yves Beaulieu
Reviewed in Canada on August 24, 2024
Configuration faite pour imprimante 3D et non por unCNC Ecriture sur la carte beaucoup TROP petite illisible Sa seule qualitee (belle apparence) pas suffisant pour faire fonctionner un cnc. Decevant et pas emballant Desole mais cette carte est pour moi un veritable FLOP
Client d'
Reviewed in Canada on July 28, 2024
impossible de faire fonctionner plus de 2 moteurs à la fois avec des contrôleurs externes, donc inutilisable comme contrôleur CNC 3 axes.Impossible to operate more than 2 motors simultaneously with external controllers, therefore unusable as a 3-axis CNC controller.
Bill H.
Reviewed in the United States on March 27, 2024
I'm using this to control a spindle motor on a converted 3D Printer that's been heavily modified to work as a Milling Machine. The controller comes with no documentation but it's pretty straight forward to install. I'm running 24v into the 48v connector and running the spindle (24v) off of the 48v spindle output. I found this worked better with my motor but you can also run it just fine with the 24v power input and the 24v spindle output.The two issues:This cannot be modified or updated, they state this in their ad and grbl is so stable I didn't expect it to be a problem, that was before I found the next issue.The $1 = 255 command in grbl will keep the motors active to hold them in place so they don't accidentally move on you. This command does not work with the version of grbl that these boards have on them. I have a real problem with my z axis dropping from vibration if the motor doesn't remain active. To use this board I have to keep my feed and speed set to lower numbers so it's never trying to remove too much material which would set up a vibration.Summary:It's working well within the limits that I can't keep the motors energized.
Ray J Bordelon
Reviewed in the United States on March 20, 2024
There is no tech support for this product. It was delivered without a tech sheet or any information about setup. The board has a usb port and a cable. When connected to a computer the board is not recognized.The vendor was not able to offer any help so I can only assume that the product is defective. I will be returning it.
Eric Gordon
Reviewed in Canada on October 29, 2024
Bought this Controller for my laser engraving project, love all the features it came with allowing for set up with my CNC machine too.
Recommended Products
