Shopping Cart

Your cart is empty.

Your cart is empty.

30A Electric Brushless Motor Controller, 2 Pcs ESC Speed Controller with XT60 and 3.5mm Bullet Plugs for RC Drone RC Airplane Helicopter

4.6 (5) Write Review
Free shipping on orders over $29.99

$17.34

$ 7 .91 $7.91

In Stock

About this item

  • 30A Current Operation: Made of high quality electronic components, dependable to use. Features 30A continuous current and 40A peak current.
  • High Anti-interference Capabilities: This 30A brushless ESC features a power input terminal that uses a low-impedance and high-capacity electrolytic capacitor to improve its anti-interference capabilities.
  • Quick Heat Dissipation: The output MOSFET power tube comes with an independent heat sink to minimize the temperature rise of the device. This not only enhances its but also improves the system's high-current working capability.
  • Smooth Control: The singlechip microcomputer adopts an independent voltage regulator chip, which avoids the power interference caused by the BEC load change and improves the working stability.
  • Widely Use: This brushless ESC is a practical accessory for any RC remote control drone, helicopter, FPV, and more. With its simple installation process, no complicated operations are required.


Product Description

1
1
1
1
1
1
1

Bruce Blevins
Reviewed in the United States on April 9, 2025
Junk. One was DOA. Smoked when I plugged the battery in, and the other works..kinda..motor surges inconsistently and doesn't get to full throttle. Turning the endpoint up to 150% helped with the throttle range but makes the surging much worse. Unusable product
James McNamee
Reviewed in the United States on April 10, 2025
works like it should
Torte
Reviewed in the United States on December 18, 2024
I picked these up for a twin engine foamy I'm building, and I've been very pleased with them so far. I've got some Sunnysky 2212 1200s I'm planning to run 4s. These have worked perfect straight out of the box and didn't need any syncing or programming. They have a 2a bec which is fine for about 5 servos and a receiver. Highly Recommended!
D.K.
Reviewed in the United States on December 17, 2024
Just as the other review here says, I would avoid these ESC's completely. They say 30amp rated but had them BOTH burn up at just under 10amps of current. Luckily I can fix my stuff but can't say that would happen again or for anyone else. These can't handle 10amp so I wouldn't waste your money on them.
Shawn Z.
Reviewed in the United States on November 16, 2024
I purchased these for a couple of planes that all i needed was a 10amp esc. Both units fried , one in the air at half throttle and the other was on the ground without a prop on the motor. The only application these might be considdered safe for would be a small electric air boat and hopefully its in the water when it shorts out and catches on fire. This trash cost me $400 just in equipment. Had it hooked up to a 2008 1400kv motor and 2 servos. The esc's start getting hot when the battery is plugged in. First one fried a min into flight and the second fried as i was adjusting the trim not even running the motor. Needless to say my blood is boiling .. Complete junk save yourself the problems headaches and money these will cost you.