Your cart is empty.
Your cart is empty. This conductive material (also known as "Velostat" or "Linqstat") is a nice addition for your wearable/sensor hacking toolkit. It's pressure-sensitive: squeezing it will reduce the resistance, so it's handy for making flexible sensors. And it's a lot less expensive than off-the-shelf pressure or bend sensors too! Each order comes with a 11"x11" (28cm x 28cm) 4mil (0.1mm) thick piece. We may fold the sheet into quarters to ship it to you. To remove any hard creases, simply lay flat on a table and put a heavy book on top to flatten it out.
Dimensions: 11" x 11" (280mm x 280mm)
4 mil / 0.1mm thick
Weight: 18.66g
Temperature Limits : -45°C to 65°C (-50°F to 150°F)
Heat Sealable : Yes
Volume Resistivity : Surface Resistivity :
Average User
Reviewed in the United States on April 4, 2025
Good material. Works as intended.
Christopher Martinelli
Reviewed in the United States on January 12, 2021
Cuts easy and doesn’t make a mess, it worked for my pressure switch
frances e myers
Reviewed in the United States on April 27, 2021
I used this material to make a force resistance sensor with the Velostat being the variable resistive material. It worked well, but when i pressed hard on the material, the voltage levels I received were much different. This is good for basic prototyping, but I don't think it would work on any large scale application - at least not consistently.
Joe Borkowski
Reviewed in the United States on October 23, 2020
This is a nice, thin conductive sheet that I used to replace the sensors under the panels on my Dance Dance Revolution pad. I didn't know if it would work, but it worked perfectly. I just stretched the material, one sheet covers all 4 panels, and it doesn't wear down like the aluminum tape that came with the pad. Hopefully it lasts at least a year (or more?:-)) under heavy foot stomping; so far so good.
Wilma Ingram
Reviewed in the United States on July 1, 2019
Too small :(
Recommended Products
