Your cart is empty.
Your cart is empty. 1 More Details
☼200 Lumens,28 super bright SMD LEDs, 1.5W, 30,000 hours lifespan.
☼3 lighting modes: 3000K warm white light, 4300K natural white light and 8000K cool white light.
☼Brightness dimmable, the brightness can be adjusted by the remote control,from 1% to 100% and 100% to 1% recycle.Or press the button on the side of light tube and hold for seconds to change the brightness.
☼Material:Plastic shell +Metal goose neck.
☼The picture light is powered by 4400mAh high capacity Lithium battery built-in, 4 hours fully charging with USB Wire(included) to last for 24 hour bright. The led indicator will auto off once the batteries are fully charged.
☼The remote control will operate lights within 20 feet. Up to 10 lights can be controlled by one remote control.
2 Installation ways:
Detachable Clip Mount Bracket (included)
1. Attach detachable clip Mount Bracket to light by turning the clip bracket clockwise until it is tight. Tighten by wrench(included)
2. Open clips, to attach detachable clip mount bracket to picture or frame. For thickness between 1" to 1.4" (25mm~35mm)
3. Adjust neck and tilt head to desired position.
Detachable Screw Mount Bracket (included)
1. Remove Detachable Clip Mount Bracket from flexible neck by rotating the Clip Mount Bracket counter-clockwise until loose.(Wrench included)
2. Place screw end of flexible neck into screw mount bracket.
3. Place screw mount bracket over top of the frame with the screw holes facing the back of frame.
4.Drill a pilot hole for each screw.Insert up to three screws (included) through the holes in the screw mount bracket to secure properly.
5. Adjust neck and tilt head to desired position.
*Do NOT put screws through picture. Check to make sure the screw mount is secure.
Packing List
- 1 x Picture Light
- 1 x Remote Control