Your cart is empty.
Your cart is empty. These DB26 Male Solderless Connectors are used to terminate the connection type of a cable and facilitate commissioning equipment of project. They can easily be connected to a custom length cable as well as create a custom pinout, creating a permanent and durable connection for all applications. These connectors are made with high-quality materials to ensure durability and a long life.
Technical Specifications:
Name: Thin DB26 solderless module
Plug type: male
Accessories: housing, screw, card line buckle
Connector material: Solid pure copper with gold plating
Contact Material: Solid Copper
Housing material: High toughness ABS plastic shell
Shell type: Screw lock
Pin Pitch: 3.81mm/0.15in
Cable Specification: 28-16 AWG/0.15-1.5mm2
Torque: 0.2Nm (1.7Lb-In.)
Opening size (cable port): 10.5mm/0.41″
Thickness: 16mm/0.63″
Application: tax control machine, digital camera, PLC, PDA, MODEM, set-top box, barcode machine, industrial instrumentation, etc.
Size: 55 mm×43 mm×16 mm/ 2.17″×1.69″×0.63″
Package includes:
1 x DB26 Male Solderless Connectors
2x Lock screws
2x Long bolts
1x cable pressing plate
1x 5mm tail pipe
1x 6mm tail pipe
1x 7.5mm tail pipe
1x 8.5mm tail pipe
Clarence Montgomery
Reviewed in the United States on July 2, 2024
Used this plug for a proprietary device in an industrial environment. Easy to wire up and works well so far.
Jason
Reviewed in the United States on June 29, 2024
Product worked good. But if the plug is fully populated it's very hard to connect all the wires. Also some of the screws on the terminals came extremely tight and I almost stripped them our
ALAN WRIGHT
Reviewed in the United States on January 10, 2024
Worked exactly as designed
veneff
Reviewed in the United States on April 29, 2022
This is one of few breakout connectors that include an enclosure. I needed to make some test harnesses for our manufacturers. They were very convenient, and with the included strain reliefs, I feel that they will stay intact during handling. The only issue was that 2 of the boards had broken connections between the screw terminals and the connector. On one of the boards I could see that the land work was scratched in 2 places. I had already assembled the harness (using all 26 pins), I just soldered jumpers over them. It was not visually obvious why the other board had a bad connection; but again, I soldered a jumper to fix it. I ordered 2 more boards and so far at least one of them seem to be good. I think I did a continuity test on the other and it appeared to good as well.
Recommended Products
$10.79
$ 5 .75 $5.75