Shopping Cart

Your cart is empty.

Your cart is empty.

Geekstory DY-880 TTL GPS Receiver Module With Flash HMC5883L Compass and Active Antenna - Support Glonass Beidou for Arduino FPV Aircraft CC3D Flight Control, Replace BN-880

4.5 (1) Write Review
Free shipping on orders over $29.99

$87.31

$ 42 .47 $42.47

In Stock

1.Size:Bn-880


About this item

  • DY-880TTL is suitable for Open source flight controller, not for flight control with SCM
  • DY-880TTL gps module is dual module compass, with and electronic compass IC HMC5883L
  • DY-880TTL gps module has flash to save configuration. So you do not need to reset next time when you use it. 72 Searching Channel Support Rate : 4800bps to 921600bps, Default 9600bps
  • DIts data Level is TTL or RS-232, Default TTL level. To make it be RS232 output, you need to use one TTL to RS232 converter cable
  • When you use it for Raspberry Pi, there is no driver needed but you need to install software


Description:
Compass main chip: QMC5883L
Support GPS+GLONASS (default); GPS+ Beidou; GLONASS+ Beidou multi-mode output
Product size: 28X28X8.5mm
Built-in LNA signal amplifier
Built-in Flash, freely configure product baud rate, output statement, output rate, second pulse and other parameters
Built-in TCXO crystal and Fara capacitor for faster hot start
1-10Hz positioning update rate
Baud rate 4800bps-921600bps (default 9600bps)
Channel: 72CH
Horizontal accuracy: 2.0m
Output level TTL level
Output Protocol NMEA0183 Standard Protocol
Update frequency 1-10 Hz (default 1Hz)
Connector: 6Pin 1.25mm Pitch
Package Includes:
1 X DY-880TTL GPS Module
3 X 6P 1.0mm Pitch Cable


RZ
Reviewed in the United States on December 29, 2023
I’ve had GPS's on about 6 of my 800mm drones for ~10 years but for this latest freestyle build i have purchased 2 GPS’s from two different manufacturers and not one works. this one doesn’t even get a blue blinking led. nothing. Dead DOA. WTH. I had to pull one from another quad of mine and I hate doing that.