VEHICLE COMPATIBILITY:
Inboard Propeller Puller is suitable for most vehicles.works on inboard with 3/4" to 1-1/8" shaft size.
PRODUCT INFORMATION：
- Color: Black, Silver Tone
- Material: Metal
PERFORMANCE:
- Works on 3/4" to 1-1/8" shaft diameters.
- These make the puller tough and sturdy enough to achieve a good anti-corrosion and anti-rust effect.
- Designed to remove 2, 3, and 4 blade propellers on inboard shafts. These tools have fine thread screws to enable a strong pulling force with little effort.
- Remove the cotter pin. Loosen the prop nut twice (do not remove the nut).
- Back out the prop puller bolt to allow for installation of the puller. Put the puller between the forward end of the prop hub and aft of the strut.
- Tighten the puller bolt clockwise with a wrench. Don't tighten too much.
- After the puller is firmly in place and the puller bolts are tightened, tap the opposite end of the puller with a hammer. Steps 3 and 4 May need to be repeated.
- When reinstalling the propeller, a thin layer of grease or anti-tightening film can be applied to the shaft/hole taper, but do not apply too much. Also, do not tighten the support nut too much.
NOTICE：
- a. This is a non-OE items, accessory ONLY！
- b. Please check your Car Model, reference our product before purchase Before.
- c. Due to manual measurement, the size deviation is about 1-2 cm.
INSTALLATION：
- DIRECT INSTALL: Direct replace the broken Inboard Propeller Puller
