Your cart is empty.
Your cart is empty.
Specifiction
Condition: 100% new and never used
Replace Part Number: 698479 591925 698475 693518
Package Listing: 1x carburetor 1x repaire kit
Compatible
Replacement for Briggs Stratton models: 698479 591925 698475 693518
Pls Note
Please check pictures for more details before purchasing, so as to prevent buying wrong and unnecessary expenses
THE REPAIR GUY!
Reviewed in the United States on November 22, 2024
CARB FITS GOOD. ENGINE RUNS AND STARTS LIKE NEW.
user
Reviewed in the United States on June 4, 2021
Only had to use the OEM choke lever.Had to slightly modify one gasket, very easy. Also needed a bit longer gas line.This was replacing a carb on a old garden tiller.The engine ran great with new carb!
KRHzy
Reviewed in the United States on February 3, 2021
Replaced gummed up carburetor on chipper/shredder. Easy to install and price was good. Much easier than trying to clean old carburetor.
Customer
Reviewed in the United States on September 24, 2020
Carburetor looked really official. However, it did not fit model 698475. The choke mechanism was completely in the way of the air filter housing. I was able to modify. Bigger problem occurred once the gas tank was filled half full. The carburetor float wasn't able to stop gas from flowing into the carburetor bowl. The problem was that when they copied the Briggs, they failed to include a rubber grommet to seal off gas flow. Flooded the air filter and cylinder with gas. Threw it in the trash and bought one built in USA.
twamane
Reviewed in the United States on June 4, 2019
I used this carb on my 6.5 hp craftsman roto tiller. I already knew what was wrong with the carb on it--it just needed a needle valve seat--just the seat alone since the swell up sometimes. I looked at buying just the needle and seat. It was about $7 with prime shipping for a package of several. This carb wasn't much more so I just bought it. The levers that came with it did not fit my application so I too had to use my own choke lever. After installation and letting the bowl fill up for a minute, motor started on 2nd pull.
Recommended Products
