Shopping Cart

Your cart is empty.

Your cart is empty.

Logarithmic Power Detector Meter AD8317 1M-10GHz 60dB RF Power Meter Logarithmic Detector Controller for Amplifier 50 Ohms

Free shipping on orders over $29.99

$16.16

$ 7 .19 $7.19

In Stock

About this item

  • WIDE APPLICATION---The logarithmic power detector could be widely used radio frequency detection, power measurement, environmental field strength detection, or as a part of automatic gain control and automatic level control
  • APPLICATION AREAS---The logarithmic power detector could be used for RF transmitter PA set point control and level monitoring; Power monitoring in a radio line transmitter; RSSI measurements in base stations, WLAN, WiMAX, and
  • 55dBm to 0dBm---The logarithmic power detector can detect power in -55dBm to 0dBm of an RF , so that the RF is converted to DC voltage output
  • 55dB---The greater the amplitude or power of the RF , the higher the output voltage, and the output voltage is directly proportional to the logarithm of the input amplitude, thus expanding the dynamic range of the detected , which ranges reach 55dB
  • AD8317 CHIP---The logarithmic power detector is designed by using AD8317 chip, and is used for RF power detection



Product Description

1
2

Specification

Input impedance: 50 Ohms

Output impedance: 50 Ohms (video impedance)

Working frequency Freq: 1MHz ~ 10GHz

Output voltage range: 1.6 ~ 0.4v (corresponding to -55 ~ 0 dBm)

Input/output ratio: 22mv /dBm

Input dynamic range: -60 ~ +5dBm (high linear dynamic range: -55 ~ 0 dBm)

Power supply voltage: +3.3~5V.DC @20mA

Size: 6.5*3.5cm/2.6*1.4in


Weight: Approx.9g/0.3oz

3

Package list


1 x Logarithmic Power Meter

4

5

6

7

8


Philipp B.
Reviewed in Canada on December 27, 2024
Comes without any description. Nothing tells you what value translates into what db?!?Once you search the internet for hours for helpful instructions you will figure out that this thing does pretty much nothing except waste your time. What a joke!Goes straight back. Total waste of time and money!
CARL C
Reviewed in the United States on January 18, 2024
The schematic shows what it should look like when you're finished and not what is on the board. I've attached an image that explains how to set it to measurement mode and also how to adjust the slope swing. If you prefer to use something that doesn't look like it was made by a monkey, you can use the AD8317 datasheet on the Analog Devices website.Other than that, item works as intended. Will purchase again.
Thomas A Wilson
Reviewed in the United States on April 19, 2024
Consistant reading with changes in power but scale changes alot with increase in frequency. Don't know if I can find a use for this unless the signal frequency is constant.
Recommended Products

$13.81

$ 6 .47 $6.47

4.3
Select Option