Your cart is empty.
Your cart is empty.Metra 95-6528B double DIN dash kit for 2006 - 2010 Dodge Ram (Black).
Paige L
Reviewed in Canada on April 28, 2024
Jodi cook
Reviewed in Canada on April 20, 2024
Easy to install, had to grind some of the site out of it to fit the stereo I got but that’s not the products fault. Looks good and works well.
Sjleafs
Reviewed in Canada on February 2, 2023
Great transaction, looks great and easy to instal!
Camo
Reviewed in Canada on December 4, 2023
Worked great, perfect fit and easy to follow instructions, installed on 08 ram 1500
👌👌👌 fit 07 dodge ram perfectly
Reviewed in Canada on December 11, 2023
no problem.. looks good and fits perfectly
Dwight Kirkwood.
Reviewed in Canada on April 10, 2023
It worked ok but required a little modification
Jamie Robertson
Reviewed in Canada on September 7, 2022
It worked , had to cut 1/8 inch from the opening to fit Chinese double din .
Andrew Carmichael
Reviewed in Canada on July 13, 2020
Installed in a 2008 Dodge Ram 1500. Extremely easy to install. You have to saw one piece off and remove the little storage tray below the old radio. This piece fits right over and snaps into place. Good luck! Highly recommend. It took me 3 minutes to fit it into place.
Nick
Reviewed in the United States on April 16, 2020
After looking at a few different options I choose to give this one a try. It does involve modifying your dash, which was simple. The Fitment was nice, but as others have stated the radio does sit inward a bit. I Didn't like this look. So after some cutting with a dremal with a plastic blade and a bit of filling on the plastic skirt, I managed to get the double din to sit in nicely. It is now flush and looks pretty good. Over all I'd recommend this kit, although it takes some tinkering to make it perfect. The unit I installed was a boss 6.2 BV9384NV
marlene
Reviewed in the United States on August 5, 2019
installed a Pioneer AVH-1300NEX 6.2" Double DIN DVD Receiver in my 2006 dodge 2500. This kit made the install. The fit was perfect (you remove the under old radio storage). The install easy. It looks nice and clean; very good quality.
jkasperows
Reviewed in the United States on December 31, 2018
Fits my pioneer perfectly. People have said that this need to be cut to fit a double din and somehow it’s not a good fit. That is incorrect. This besel fits the first edge of the faceplate for the double din. The Whole stereo is NOT supposed to fit in it. A bit of plastic trimming and boom! Bad ass fit!
Customer
Reviewed in the United States on January 11, 2017
Follow manual - My review is informational only!Dash has the standard radio, with the half moonsI own a 2006 dodge ram 2500, Diesel. These trucks don't have your typical dash kits. it made things confusing when trying to figure out what one to get! I only bought this one as another review on this had a picture along with helpful information.This kit does work fine however you need to note a few things. Cutting of the factory panel is required. If you have a dremel or some type of cutting disk where you can control it, this is cake! Basically you take your factory panel, cut the piece that divides the stock radio and the storage compartment. Once that is done, cut off 1/8th inch on both sides on the unit(where the half moons are). This is all stated in the manual as well.Then the face-plate snaps in. You want to take your time and measure to make a perfect cut. Cut off to much then you just costed yourself some money, the replacement panels are pricey.Another note I have is the stock radio does not have a switched source! I ran into this issue, got everything wired up and the radio would not turn on. Rewired, still nothing. Thanks to a Amazon Review on another product this was mentioned! I tapped into the cigarette lighter, to get the 12v switched source. Once this was done, radio turned on.I have a picture attached.Again, take your time and measure. The right tools will make this easy, the wrong tool will more than likely destroy the dash panel. Remember, its plastic!
NB
Reviewed in the United States on April 28, 2016
Great solution to expensive alternative options. Let's be honest, you've got more money than sense if you spend upwards of 200$ on a factory "double din" or "nav" spaced center dash cover just to swap a single din to a double sized stereo. This part looks great, and is a simple install. If you have a dremel it's even faster.I installed this in less than an hour and even popped it all in place without wiring, as a dry run to see if it all lined up properly. Any reviews stating they "broke pieces" or "it looks terrible and doesn't line up" probably didn't do it right and caused the issues themselves.Easy. And clean looking. Done.A SLIGHT space may be left on top/bottom depending on what stereo you install but it's hardly noticeable. And if it is, a small piece of abs sheet will slide in and hide it if you're a perfectionist or can see any lighting/etc showing through. I'm not going to even bother. It looks great as is with my pioneer radio
Recommended Products
$15.26
$ 7 .19 $7.19