Your cart is empty.
Your cart is empty. What You Get:
1 * Touch Switch
1 * Instruction
What's the Touch Switch:
Touch switch, just touch it!
What's the Touch Switch Used for:
Most often the Stepless Dimming switch is used for lights.
(Such as critical lights, chassis lamp, dome light)
Memory Function:
The UT19T12 switch can remember the last dimmed state of your light!
When you enable again in either high or low power mode it returns to that level.
About Stepless Dimming type:
1.The light (device) is off when connecting to electricity.
Click it (time Click it again to let it be off.
Continue to cycle.
2.The initial brightness is 100% of the maximum brightness.
3.Touch and hold it (time > 550ms) to initiate stepless dimming control.
The brightness increases when touching and holding, and stays at the level when stop holding.
When holding more than 3 seconds, the brightness reaches and stays at maximum level.
The brightness decreases when touching and holding again, and stays at the level when stop holding.
When holding more than 3 seconds, the brightness reaches and stays at minimum level.
Continue to cycle.
4.Click and Holding Touch can be used anytime.
There is no interference between these two functions.
What's Note:
*The touch switch can't be used on a pump.It will be burnt out easily.
*If you meet the static electricity problem, you can let the switch housing be grounded.
*The touch switch doesn't work with wet or damp fingers.
*The touch switch cannot be used in AC circuit. Don't exceed the rating volts!
Specifications:
Head diameter: 7/8" ( 22mm )
Mounting hole size: 3/4" ( 19mm )
Depth inc contacts: 1.1" ( 28mm )
Switch Type: Stepless Dimming
Input Voltage: DC 6V-24V
Output Current: 7A MAX
LED color: Blue (LED ON when device ON)
william t bernard
Reviewed in the United States on February 19, 2025
Most of these switched have really short threading. I was installing lights under my cabinets and bought different buttons. They fit and could be secured but it was not a tight fit this one is long enough ot get a good fit for that job. Recommend
Troy D.
Reviewed in the United States on September 26, 2024
I felt like Goldilocks trying to find a dimmer switch that didn't make my lights makes lights buzz or have some abrupt transitions in the output. This was the only one I found that actually worked on my lights, and I like the fact the company has a lot of different options from stepless, to memory functions, illuminated switches, etc. And the materials are not cheap plastic. The wire gage seems adequate for the task.The step version only has three output levels so if you want more you would have to go to the stepless version, and I can't say that version is rather finicky to adjust. I think the stepless version has a memory function as well. Again, it's nice this company has some options.Overall it's a good switch, at least based on the limited time I've had it and used it.
Matt
Reviewed in Canada on January 3, 2024
I have bought two of these and one of them died after a year and the other has been good for three years. When it works it is perfect and dims very easily! I am going with three stars even though one failed a little soon, as I do quite like them.
Steven S.
Reviewed in Canada on September 7, 2023
Bought another style dimmer first which was a plastic piece of junk that was a chore to install and it fried upon my attempt. This one is easy to install works beautifully and I was so pleased I bought another!
Alan Pascoe
Reviewed in Australia on July 25, 2023
Delivery this time is slow, the date has been reset twice and still not received at this point I have used one before and delivery was fine. The product worked as described in my testing and it works very well hence why Im buying another. We are using it to dim and control six led 12v down lights in our yacht. Not all of these work directly without a controller, but this one does very well. The LED blue light is on all the time. The Dimming scale is prefect except for the last 10% which goes quickly and my wife overshoots. However, I think that is the LED's Not the Dimmer. I expect I will buy more.
Saad
Reviewed in the United Arab Emirates on February 19, 2022
Very Good materiel ,
David
Reviewed in Canada on August 12, 2021
Perfect replacement for the dimmer switch on our Costco light, easy to install and works as expected, happy to not replace the whole lamp at this time.
AMPS
Reviewed in Canada on June 13, 2021
Perfect for the outdoor light on our van. Smooth dimming, very responsive touch function. Highly recommended for the price.
Bill M
Reviewed in Canada on February 22, 2021
Initially I was happy with the unit, looks good felt solid and worked well, I did notice that it did get warm. it was running a small LED light strip in a 12 v lamp 24watt lamp (2 amps draw), well under the 7 amp specVery disappointed that the switch failed after 8 months use.
H. Stone
Reviewed in the United States on April 28, 2021
I had a similar type of light control for lights over a gas cook top. The other light control had continuous lighting control, which I found a little unwieldy. I decided to purchase this control with stepwise dimming. It was very easy to remove the existing control and replace it with this one. It was just a matter of undoing wire nuts on low voltage wires and retwisting those same wire nuts with the new controller. I have two LED lights that are controlled, and everything works just fine. Having used the system for a few weeks, the only thing that I would do differently is to order the version of the controller that is on/off, rather than the one that I ordered which allows stepwise dimming. It turns out that I would prefer to choose just on or off rather than to choose a light level each time I turn the light on. This is a minor issue, and could be fixed if there were an option to select a light level, and return to that level automatically each time the light is turned on. But the simple on/off switch is perfectly adequate, and no dimming is necessary for the particular LEDs that I have over the gas cooktop.
Seanaoneill
Reviewed in Canada on September 16, 2020
Bought these to dim the led strips on my camper. First test was to wire- IN to the 12V line, OUT to the LEDs, then I tied the 2 negatives (grounds) together and grounded. The switch would work on off, no dim. I then separated the negatives- the out negative to the LED neg, and only the input negative to the camper ground- works perfectly.Note- when you turn the source off (input off, for me, there was an awning LED switch inside, that we would turn on/off from inside), the switch defaults to OFF. So turning the switch inside back on, would not make the LED strip come back on, since this switch was off. Back outside, press on, press and hold to set brightness. Since my controller is also an App, this was the only way that we could use this- 2 step. Bummer it won't remember Last Stage or something like that.
Panic Expert
Reviewed in Canada on August 4, 2020
These are well built, they feel solid in your hand. The threads feel good, the dimming and sensitivity are on point - all in all its a nice switch. I used them with LED lights, and the work perfectly.The blue led stays on, all the time - so be sure that you know that before you buy.
AtomicBen
Reviewed in Canada on October 2, 2019
I'm building a camper van. I have 6 LED lights for the ceiling. This dimmer is SO cool. Just putting my finger on it and watching the lights dim, amazing. I don't want to put a picture because I was sloppy with cutting the hole but this switch is literally the coolest little device in my van. I love the little blue LED ring around the button. We placed it closer to the floor to not disturb us at night and we can just lean over the bed and touch it and BAM, light. Whenever I show the van to friends and co-workers, this dimmer is easily the coolest gadget because people can interact with it. It's got a smooth transition and stops before the lights would go all flickery. Such a cool design. Love it! Thank YOU!
Recommended Products
$53.99
$ 24 .47 $24.47