Your cart is empty.
Your cart is empty. Walfront 10000W SCR Digital Voltage Regulator Speed Control Dimmer Thermostat
Widely used as heat controller on electric stoves, water heaters, light dimmer on lamps, speed controller on small motors, or temperature controller on electric soldering iron, etc.
Specifications:
Voltage: AC 220V
Max Power: 10000W(instantaneous limit power for impedance load; for long time use, 5000w or lower is recommended)
Voltage Adjustment: 0-100% (nonlinear)
Controller Size: 95.7*56.7*53.8mm/3.76*2.23*2.11"
Panel Size: 74.6*59.8*2.3mm/2.93*2.35*0.09"
Cable Length: 287mm/11.3"
Note:
1, AC input, AC output, output voltage is lower than(or equal to) input voltage; voltage can be adjusted only when connected to load; mainly used for resistive load.
2, It can not replace electric bicycles' battery , nor drive electric appliances which use switch power supply (such as 110V TV, speaker, refrigerator, air conditioner, rice cooker with a computer), and cannot drive induction cooker, energy saving lamp.
Package Includes:
1 x SCR Controller
1 x ABS Panel
1 x Panel Sticker
1 x Cable
Max Muster
Reviewed in Germany on June 11, 2024
Bei mir Verwendung mit einem Heisswasserspeicher. Die Einstellung geht nach neuerlichem Einschalten nicht verloren.
Alejandro
Reviewed in Spain on March 15, 2024
Había probado muchos de estos de 30€ este el mejor aún dura todo genial
buytherock
Reviewed in Canada on January 3, 2024
Si simple, rien à apprendre... pour un électricien comme moi. Par contre, pour le commun des mortels, plus d'explication est nécessaire.
dave
Reviewed in Canada on March 23, 2023
Used this with a 5500w heater element in my still and it works great
pandora78
Reviewed in France on November 27, 2023
Le boitier aluminium vient d'une alimentation 220vac/12vdc Hs.Dimensions du Boitier L10cms l13.5cms H7,5cms.Le Module est alimenté en 220vac via un interrupteur et un fusible général. Jai ajouté un afficheur digital pour visualiser la tension de sortie.Pour un meilleur refroidissement le dissipateur du module est fixé au boitier et j'ai ajouté un ventilateur protégé par un fusible.J'utilise une Plancha électrique à deux résistances et Thermostats bilames pour contrôler la température des plaques.La température des plaques varie en permanence au gré des coupures et des remises sous tension des thermostats , j'ai mesuré jusqu'à 50° d'écart entre ces deux phases. (thermomètre infrarouge à visée laser).J'alimente donc ma plancha via le variateur de puissance , et je règle à fond les thermostats pour qu'ils n'interviennent plus, sauf à température maximale 330°environ.J'ai donc une plancha alimentée en permanence, des températures constantes et la puissance utilisée correspond à la température demandée, et pas 2300w ( puissance max de ma plancha).Un vrai confort qui rappel les planchas à gaz ou la température est fonction de la hauteur de la flamme.Pourquoi utiliser ces thermostats archaïques ?
PCM
Reviewed in the United States on May 26, 2022
Used this to build a complete 120VAC voltage regulator in a food storage container that worked perfectly. It was connected to a 1000W hotplate that had its temp control disconnected. This was so I could fine tune the plate's temperature up or down, one volt at a time. I used spacers to keep the heatsink of the controller 1.5" above the bottom of the plastic and drilled air holes for venting in the top and the bottom. It never overheated and worked flawlessly.
Ethan
Reviewed in Canada on March 2, 2022
I wish the product came with a enclosure or casing
James T Hutniak
Reviewed in Canada on November 6, 2022
Made an in-line, motor speed control, extension cord. The device delivers a constant reliable current while reducing the motor speed.
Steve
Reviewed in Canada on July 9, 2021
it was broken and missed parts when deliveredI cannot test
Taylormade181
Reviewed in Canada on March 6, 2021
So far I haven’t been electrocuted and it works as it should!
Colin Trail
Reviewed in Canada on February 9, 2021
Great product
Frank
Reviewed in Italy on September 1, 2019
Il regolatore è stato utilizzato per il controllo della velocità di un motore asincrono monofase. Ho potuto constatare , con una certa sorpresa, che funziona sia con motori a condensatore che con motori a circuito di avviamento. Unico neo, che ha determinato le quattro stelle è che la regolazione avviene nel campo 50% - 100%. Infatti il more si ferma appena si scende sotto il 50% e questo indipendentemente dalla potenza del motore.
Laura L.
Reviewed in Canada on June 14, 2019
Very cool tool. Works great with my 220v 5500w heating element. Just didn't come with mounting screws for face plate.
Recommended Products
