Shopping Cart

Your cart is empty.

Your cart is empty.

226 Buna-N O-Ring, 50A Durometer, Round, Black, 2' ID, 2-1/4' OD, 1/8' Width (Pack of 15)

Free shipping on orders over CA $49.99

CA $13.58

CA $ 6 .99 CA $6.99

In Stock

About this item

  • Made of Buna-nitrile (also called Buna-N) for use with a variety of fluids from petroleum to aliphatic hydrocarbons
  • Durometer (hardness) of 50A for resistance to penetration
  • Round cross-section to provide a seal between cylindrical overlapping surfaces
  • Colour : Black


This O-ring is made of black Buna-nitrile (Buna-N) and has a durometer of 50A. It has a round cross-section and can be used across a wide temperature range (-30 degrees F/-34 degrees C to 250 degrees F/121 degrees C). Designed for use in a wide variety of sealing applications, this Buna-nitrile O-ring meet standards defined by Aerospace Standard AS568A, which is the Aerospace Size Standard for O-rings. Buna-nitrile can have high tensile strength, as well as abrasion, tear, and compression set resistance. It is compatible for use with petroleum, hexafluoroacetone (HFA), hexafluoro-2-butyne (HFB) and hydrofluorocarbon (HFC) fluids, vegetable oil, alcohol, acids, and aliphatic hydrocarbons. Buna-nitrile is vulnerable to acetone, ethers, esters, ozone, sunlight and weathering, and should not be used in ozone-generating electric motors, welding equipment, or in applications with exposure to UV light. The durometer hardness of this Buna O-ring is 50A. Durometers measure the hardness of a material and its resistance to permanent indentation. A higher durometer value indicates greater resistance to indentation. On a scale of 0 to 100, a value of 0 indicates that a sample was completely penetrated, while a value of 100 shows no indentation in the sample. The letter following the number identifies the shore scale, which is either shore A or D. Shore A is used for softer plastics, while shore D is used for harder plastics. O-rings provide a pressure and fluid seal between cylindrically shaped, overlapping mating surfaces and are commonly seen in engines, faucets, flanges, valves, and various cylinders. They are circular in shape, with a round cross section, and a hole in the center, similar to a doughnut. O-rings are available in various AS568A dash sizes, which is the standardized sizing for O-rings, and defines the nominal inside diameter (ID), outer diameter (OD), and cross-sectional (CS) diameter of an O-ring.


Pat Bruder
Reviewed in Canada on May 1, 2023
Very good quality and price
Steve Berger
Reviewed in the United States on September 29, 2014
good quality
Recommended Products

CA $8.53

CA $ 3 .99 CA $3.99

4.4
Select Option

CA $11.59

CA $ 5 .99 CA $5.99

4.5
Select Option

CA $32.03

CA $ 13 .99 CA $13.99

4.7
Select Option

CA $9.26

CA $ 4 .99 CA $4.99

5.0
Select Option