Your cart is empty.
Your cart is empty. Connection instructions.
The two thick wires of the isolator are connected to the positive terminal of the main and secondary batteries respectively according to the connection diagram. The thin black wire is connected to the negative terminal of the main battery, and the emergency start switch wire is connected to the signal wire of the ignition switch control.
Under the normal operation of the isolator, the blue light will be on or flashing. When the main and vice battery are out of power, press the emergency start button to borrow power to start the car engine.
- Input voltage: 12V/24V working voltage and load voltage
- Continuous current:250A normally open type
- Peak current:250A Normally open
- Auto-connect voltage:13.5V-16V (12V)/27V-32V (24V)
- Auto disconnect voltage: 12.5V, disconnect immediately if lower than 12.5V
- Overvoltage: 16V/32V
- Weight: 700g
- Size: 6*5.8*1.6inch
Suresh kumar
Reviewed in Canada on March 31, 2025
I don’t know Chinese language?
The MotorMan
Reviewed in Canada on November 5, 2024
So far so good!
Recommended Products