Your cart is empty.
Your cart is empty.(2PACK) SEPC Snow Blower Paddle For Toro 99-9313 with Screws Set THIS PART IS USED IN MODEL. 28226 (720E SNOWTHROWER) 33005 (INSIGHT 1000 SNOWTHROWER) 33006 (INSIGHT 1000 SNOWTHROWER) 38180 (CCR 2000 SNOWTHROWER) 38180C (CCR 2000 SNOWTHROWER) 38181 (CCR 2000 SNOWTHROWER) 38185 (CCR 2000 SNOWTHROWER) 38185C (CCR 2000 SNOWTHROWER) 38186 (CCR 2000 SNOWTHROWER) 38409 (CCR 2400 SNOWTHROWER) 38410 (CCR 2400 SNOWTHROWER) 38411 (CCR 2400 SNOWTHROWER) 38412 (CCR 2400 SNOWTHROWER) 38413 (CCR 2450 SNOWTHROWER) 38414 (CCR 2400 SNOWTHROWER) 38415 (CCR 2400 SNOWTHROWER) 38416 (CCR 2400 SNOWTHROWER) 38417 (CCR 2400 SNOWTHROWER) 38418 (CCR 2400 SNOWTHROWER) 38419 (CCR 2450 SNOWTHROWER) 38420 (CCR 2500 SNOWTHROWER) 38421 (CCR 2500 SNOWTHROWER) 38422 (CCR 2500 SNOWTHROWER) 38423 (CCR 2500 SNOWTHROWER) 38424 (CCR 2500 SNOWTHROWER) 38425 (CCR 2500 SNOWTHROWER) 38426 (CCR 2500 SNOWTHROWER) 38427 (CCR 2500 SNOWTHROWER) 38428 (CCR 2450 SNOWTHROWER) 38429 (CCR 2450 SNOWTHROWER) 38430 (CCR 3000 SNOWTHROWER) 38431 (CCR 3000 SNOWTHROWER) 38432 (CCR 3000 SNOWTHROWER) 38433 (CCR 3000 SNOWTHROWER) 38435 (CCR 3000 SNOWTHROWER) 38436 (CCR 3000 SNOWTHROWER) 38437 (CCR 3000 SNOWTHROWER) 38438 (CCR 3000 SNOWTHROWER) 38439 (CCR 3600 SNOWTHROWER) 38440 (CCR 3650 SNOWTHROWER) 38441 (CCR 3650 SNOWTHROWER) 38442 (CCR 3650 SNOWTHROWER) 38445 (CCR 3650 SNOWTHROWER) 38515 (CCR 2450 GTS SNOWTHROWER) 38516 (CCR 2450 GTS SNOWTHROWER) 38517 (CCR 3650 GTS SNOWTHROWER) 38518 (CCR 3650 GTS SNOWTHROWER) 38535 (CCR 2450 GTS SNOWTHROWER) 38536 (CCR 2450 GTS SNOWTHROWER) 38537 (CCR 3650 GTS SNOWTHROWER) 38538 (CCR 3650 GTS SNOWTHROWER)
ken
Reviewed in Canada on January 21, 2025
they were used on a Toro snow thrower
Customer
Reviewed in Canada on September 30, 2023
Great items. Good value.
Andrew
Reviewed in Canada on March 16, 2023
Item as described, fits my 721QZR perfectly. The new hardware is a must, most of the old stuff broke when removing the old paddle.
Barry Milaney
Reviewed in Canada on February 3, 2023
A bit tricky to install - but so are the original Toro paddles!Start with the outside bolts - do the center bolts last.Use an open end wrench with a bit of masking tape to hold the nuts.(take a picture before you remove the old paddles.)
Laura K.
Reviewed in Canada on December 20, 2022
I don,t know we ordered paddles before and had no problem putting them on. These ones here were terrible to put on. Bolts were shorter then original ones and had a hard time lining up holes.
Allan
Reviewed in Canada on November 12, 2020
I was a little worried if they would fit correctly. But they did. I am happy with my purchase. Delivery was quick. I would purchase them again when needed.
Richard
Reviewed in Canada on October 21, 2020
No fault product, its just you need some patience and many hands or many needle nose vise grips to install. I needed another set of hands to hold back nut with needle nose plyers while the product was held in place near the bolt holes by 2 vise grips. Loads of fun!!
Customer
Reviewed in Canada on January 27, 2020
Fit is good, just like factory paddles. Life may be slightly less than factory but for the price they are a good value. For homeowner use they should last 1-2 seasons. We use these commercially and find we get about half a season, 10 snow falls, before they hit the wear line. Getting new fasteners is a bonus. Delivery was quick.
Recommended Products
CA $22.29
CA $ 9 .99 CA $9.99
CA $49.00
CA $ 22 .99 CA $22.99
CA $16.55
CA $ 6 .99 CA $6.99