Your cart is empty.
Your cart is empty.Product Description
- Below Battery Voltage Control Parameters are in 12V system, please double the values in 24V system
- Equalization: B01: sealed 14.4V / B02: Gel 14.2V / B03: flood 14.6V
- Float Charging Voltage: 13.7V
- Low Voltage Disconnect Voltage: 10.7V
- Low Voltage Reconnect Voltage: 12.6V
Battery Voltage Control Parameters (defaul,adjustable)
1. Floating charge Voltage (HVD 13.3V-14V) 2. Recovery after under Voltage (LVD 11V-13.5V) 3. Under Voltage protection (RVD 9V-12.3V)
Features:
- Batt voltage: DC 12V/24V Auto
- Charge /Discharge current: 30A
- Max input Power 360W (12v system), 720W (24v system)
- Solar Panel VOC Rang: 14V - 24V (12V battery), 28V<48V (24 battery)
- Two USB output: 5V/3A
- Load Mode: 24 hours, 1-23 hours, 0 hour
- Battery Option : 1. AGM = Sealed、Flooded / OPEN. 2. GEL
- Operating temperature: -35℃-60℃
- Protection:short-circuit protection /open-circuit protection / reverse protection / over-load protection.
- Suitable for small solar energy system.
Installation Procedure:
- Screw the adjustment screw counter clockwise until the plates moves down.
- Insert the wire into the new opening between the plate and the "top" of the Terminal hole, not under it.
- Screw the adjuster clockwise and the plate will move upwards thereby squishing the wire in the Terminal hole.
Installation STEPS：Connect the system in the order of 1.Battery > 2. Load > 3.PV Array, disconnect the system in the reverse order 3. 2 .1.
- The regulator is only suitable for lead acid batteries: OPEN, AGM, GEL, not for nickel hydride, lithium, ions, or other batteries.
- Make sure your battery has enough voltage for the controller to recognize the battery before first installation.
- When the battery voltage is too low, the controller will stop output (≤ 8V, controller turn off itself, LCD is blank,≤10.7V, 12Voutput ports are not available); after the solar panels charging, the battery will return to 12.6 V. It is a natural to output.
- Float voltage should be higher than battery voltage.
- This RBL serise charge controller only fit for small solar system!!!
Warm Tips: Only voltage reading in the screen of the solar controller, no amps or amp hours.
Walter Kneip
Reviewed in Canada on February 8, 2025
I've been using the 30A Solar Charge Controller 12V/24V Auto for a few months now, and it has performed exceptionally well. It automatically adjusts to 12V or 24V systems, which makes it very versatile. The LCD display is clear and easy to read, showing all necessary information like charging status, battery voltage, and load control. The controller's protection features, including overcharge, over-discharge, and short circuit protection, have given me peace of mind. It's also very easy to install and has been working flawlessly with my solar setup. Highly recommend this solar charge controller for anyone looking to optimize their solar power system!
Pat
Reviewed in Canada on August 7, 2024
as soon as I connected a regular 100w solar panel it heated and started to make smoke. disconnected and threw in the garbage. poor quality going to buy a better one. get what you pay for.
Bride Peddle
Reviewed in Canada on August 31, 2024
Wouldn't change the kettle, but ok for cel phones and tablets
Dan
Reviewed in Canada on May 2, 2024
exactly what I was expecting No issues with the product definitely would purchase again.
Oleksandr Byelko
Reviewed in Canada on October 19, 2024
Good job
Jeff
Reviewed in Canada on December 30, 2023
Really nice for a small (portable/mobile) set up. I first set it up for camping in a protective case. I will be installing it in my 76 Apache hardwall camper.
Barry
Reviewed in Canada on April 14, 2023
As advertised. Seems to work well
Martin Meisenbacher
Reviewed in Canada on May 10, 2020
Set my panels up, which were purchased from a local hardware store on a very good impossible to pass over sale. This controller is now running two 100W 12V panels and keeping two large marine deep cycle batteries charged all day to run my DIY sound system, which runs at 320W max. At night I sometimes give it a 20 minute charge with my wall charger simply to keep the batteries healthy... I can use a third panel if I want to keep these 50lb 105ah X2 in parallel batteries at a permanent float charge.. But it's nice to know that my goal of using my own renewable energy via sun and wind has finally begun fruition. Currently working on two self built wind turbines.. Going to grab a third panel too once the funds are available to allocate to the cause.. I love how I can set cut off voltages for battery discharge and also charge cutoff to prevent overcharge too. This summer's goal is to get the same 110ah batteries to run in series to power one of my UPSs and have either an eco friendly computer/soldering setup or one to run my indoor garden and some low wattage power tools. I would, at this point, definitely buy another when I need it. Looking into wind turbine rectifiers at the moment.
Recommended Products