Your cart is empty.
Your cart is empty. Specification:
Condition: brand new
Weight: 239g/8.4oz
REX - C100 thermostat:
Model: REX-C100FK02-V*AN DN
Measurement accuracy: ±0.5% FS
End to end compensation tolerance: 0 ~ 50 ℃ can be through the software to modify + 2 ℃
Resolution: 14 bits
Sampling cycle: 0.5 seconds
Power supply: AC 110-240V 50/60hz
Process value: (PV)
Set value: (SV)
Output, alarm and self-setting indicate: by LED
PIN control: including ON/OFF, stepper PID and continuous PID
Self-adjusting control: Yes
Delayed output: capacity 250V AC 3A (resistance load)
Alarm function output: No
Proportional band (P) : 0 ~ full range (ON/OFF control set to 0)
The testing temperature range: 0 ~ 400 ℃
Insulation resistance: > 50M ohm (500V DC)
Insulation resistance: 1500V AC/min
Insulation resistance: power consumption The environment of service: 0 ~ 50 ℃
Non-corrosive gas environment 30 ~ 85% RH
Temperature input type: K-type thermocouple
Size: 48 * 48 * 110mm / 1.9 * 1.9 * 4.3in
K Type Thermocouple:
Length: 1m
Diameter of sensor: 4.5mm
Temperature range: 0 ~ 1300 ℃
Internal insulation: fiberglass
External shielding: insulation shielding
Solid-state relay:
Output voltage range: standard
Output current: 25A
Input voltage: DC 3-32V
Output voltage: 24-380V AC
Package List:
1 x REX-C100 Temperature Controller
1 x K-type Thermocouple
1 x Solid-state Relay
Customer
Reviewed in Canada on November 2, 2023
best product ever
Chris
Reviewed in Canada on October 28, 2023
This is a very basic Rex-C100, no fancy functions to play with. Not plug & play though, the instructions are less than user friendly if you don't have experience with these.
Len
Reviewed in Canada on May 16, 2022
The "M6" k type thermal couple is not M6 as it's stated and didn’t fit into my component.
Toronto User
Reviewed in Canada on March 27, 2022
The controller is good and working as it should. OOTB PID parameters are OK for the device that is changing its temperature pretty fast. Some adjustment is needed to drive larger appliance because of the reactive nature of the temperature changes. The controller can overshoot if the thermocouple is not seeing enough of the temperature change. It comes to the programmed temperature over some time. However the PID parameters can be calculated with stopwatch and reading from the thermocouple (youtube video "How to Tune a PID Controller" . After adjustment working fine. The solid state relay is getting very hot when driving large load, you need to keep that in mind and provide some kind of radiator to dissipate the heat. The provided documentation is not for a general population. Wiring diagram is pretty confusing. Search for youtube video "PID REX C100 temperature controller contact connection" for very good connection instructions. Overall good kit that allows to build DYI steady temperature setup.
Randy Q.
Reviewed in Canada on December 17, 2022
works as it should
Kenneth Rimmer
Reviewed in Canada on August 7, 2021
I am having an electrician install this on my oven for a project, He speaks only french and instructions are only English and Chinese. No wiring diagram and downloaded manual were little help. We are testing it on 110v before the oven.After some trouble shooting the unit is finally working.. It would have been impossible for me to figure this out without the help of an electrician.
Recommended Products
