Your cart is empty.
Your cart is empty.Product Description
TABLE MAT GROUND
A complete kit to install and ground ESD and Anti-Static table mats according to ANSI/ESD S20.20
LOW PROFILE
Comes with a low profile Common Point Ground Cord that snaps to the mat and provides two banana jack receptacles to ground two operators working at the station.
THICK OR THIN MATS
The kit includes a Universal Snap Kit that can install a 10mm snap or stud into materials up to 0.375" thick mats. Comes with a low profile Common Point Ground Cord that snaps to the mat and provides two banana jack receptacles to ground two operators working at the station.
EASY INSTALLATION
The snap kit is installed into the mat with Philips head screw driver. The ground cord connects to that snap and the opposite end is connected to the center screw of an outlet
David Tozer
Reviewed in Canada on August 14, 2024
As ordered.
MG
Reviewed in the United States on August 10, 2024
These worked fine to set up my workspace, easy to install, jacks have held up fine for a couple of years.
JustAddPower
Reviewed in the United States on January 8, 2024
Bought this for the lab at work. They works!
J. Santucci
Reviewed in the United States on February 7, 2021
This kit installed easily and works well. But my mat is a little on the thin side, so I had to add an additional washer in the stack. The button does sit up a little high which is an issue for when I want to store my mat away. But not a big issue. I took away a star because the button kit does not screw down tight enough on the mat. I have not done an ESD test on the setup yet, so we will see.
Customer
Reviewed in the United States on December 24, 2020
Well-grounded design, installing it was a snap.
D-----
Reviewed in the United States on December 13, 2020
This was the perfect solution to my static mat. Took only a few minutes to put together and worked like a charm.
Recommended Products