Your cart is empty.
Your cart is empty. Ampper panel mounted battery switch, battery power master switch disconnect isolator for car, vehicle, Rv, boat and more.
Specifications:
1, ABS plastic housing, durable made for safety use.
2, NO rear and side pads / covers for surface mount application.
3, On/Off 2 positions.
4, Copper terminal studs with nuts and washers.
5, 4 mounting screw holes.
6, 275 A continuous at DC 12V, 455 A Intermittent at DC 12V, 1250 A momentary at DC 12V.
7, Used for DC 12 - 48V systems panel mounted to isolate and secure the electrical system.
8, Can stand alone or be locked together with other switch.
9, Eliminate any power draw from the battery when vehicle or boat is not in use.
10, Disconnects the battery safely.
11, Universal used for Car, Vehicle, RV, Boat and More.
12, Used as electrical equipment's switch.
13, Size: 2.68" x 2.68" x 2.75".
Complete kits includes:
1 x battery switch.
4 sets of mounting bolts.
Dangerboy
Reviewed in the United States on March 11, 2025
Decent switch with good sized connections. Easy to mount.
Zdenek Pokorny
Reviewed in Canada on February 2, 2025
Excellent quality
David
Reviewed in the United States on August 31, 2024
Did a upgrade on my tracker EV and I could not run the winch on the 76volt system so I had to get a standalone battery and I did not want it to run down the battery so I installed shut off switch and I added a solar panel to trickle charge The battery. Works perfectly
GCS
Reviewed in Canada on August 18, 2024
I ordered two of these for a flush mount application. They were easy to install and seem to be very robust switches.
rogerg4003
Reviewed in Canada on August 17, 2024
tres satisfait
Customer
Reviewed in the United States on June 12, 2024
I needed a whole saw for mounting to a battery box on a travel trailer. There was just enough clearance to do so. It also works as intended.
Blain wayland
Reviewed in Canada on May 8, 2024
It works great for trailer
Don
Reviewed in Canada on February 22, 2024
This product works as describedGood product
LTD
Reviewed in the United States on February 10, 2024
This is a well-made, high quality battery switch. It arrived when promised, packaged well, and in excellent condition. The switch was easy to install in the battery cover lid of my RV and it works as promised. In RVs, using the built in disconnect switch that comes from the factory, doesn't fully disconnect everything so there is battery drainage even with that switch removed. This stops that drainage completely.I highly recommend this switch!
Stan Weisbeker
Reviewed in Canada on October 27, 2024
Finally had time to wire this up and install. To my surprise the label is incorrect. What was labeled as off is battery#2 . Either the label is wrong or they rebutted the contact block off by 90% buyer beware . If you think you’re safe? Your not!!!! It’s labeled c for common, bat 1 and bat 2 so it’s straight forward but manufacturing messed it up .
Customer
Reviewed in Canada on October 21, 2024
It will work for me but , it would be better if this recessed style (wired from inside the wall panel it is mounted to) came with 1or2 but not both ,as in my case it is adding a roof mounted set of solar panels to a portable solar array and the solar controler can not handle both at the same time . I could not find one that was wired from the back and did NOT have the both option
Angus
Reviewed in Australia on October 12, 2024
Didn't realise this didn't have a back plastic box.Comes as the switch, with the terminals, but no protection on the back. Product works great, just is only the front switch.Would not have bought had i realised this, likely my fault for not reading the description. Annoying AF.
Dennis Cadeau
Reviewed in Canada on October 11, 2021
it seems to be a good product
Recommended Products
