Your cart is empty.
Your cart is empty.Atwood Water Heater Repair parts. ECO Thermostat Assembly. Front Mount.
John arnold
Reviewed in the United States on October 28, 2023
Fit perfectly and tested for proper operation for an entire afternoon, and they worked great.
Laetitia
Reviewed in France on May 17, 2022
Produit de qualité conforme à mes attentesJ ai pu réparer mon chauffe eau de mon vieux camping car ça marche nikel
JBrown
Reviewed in Canada on August 23, 2021
Replacement for originals and fixed problem immediately.
Jim Mohl
Reviewed in Canada on August 17, 2021
Perfect kit to replace old faulty stats on the RV water heater.
Rob
Reviewed in Canada on July 12, 2021
Used it to repair my water heater in my 2017 Rinker boat
Paul R. Haller
Reviewed in the United States on March 20, 2019
Worked to repair an Atwood gc10a- 4e water heater. I had them installed in about 15 minutes. It comes with both sensors that are tank mounted and the foam cover. I could not be happier. They take some time to insert in their respective holes, but once installed work perfectly. Remember to put the t stat with the smaller electrical tabs on the right side facing the heater from outside. A quick way to install them is to remove the old sensor and pry outward slightly the three tabs on the tank. Install the new sensor and once installed with the clear plastic ring under the three tabs, push the three tabs back down hard with a screwdriver. It makes installation much easier.
Willy J
Reviewed in the United States on September 6, 2018
I installed a set of these in my friend's RV water heater and one in mine. Both are working great. The kit contains 2 thermostats. The one installed on the right with the brown wires cuts off the flame when your water reaches 60 degrees Celsius. The E.C.O. (Emergency cut off) goes on the left and connects to the red wires. It is only there to protect you if the 60 degree tstat fails. They are held in place with a plastic disk with a notch in it which you can rotate until you get the tstats in or out. It's easiest to remove the exhaust shroud to place the glue on insulating blanket over the tstats.
Mehlman57
Reviewed in the United States on August 8, 2018
This ECO and T-Stat set was exactly what I needed for my 6 gallon Atwood water heater. The set I received came with a new label to replace the old one and was packaged in the proper position over the label so I had a good idea which sensor went where even before I opened it. If there's any confusion, just remember that the higher temp sensor is for the ECO (emergency cut off) not the thermostat. Replacement of both sensors took less than ten minutes and with a new PT relief valve my unit was working perfectly again.
Jim Moreland
Reviewed in Canada on August 28, 2018
Fits correctly and easy to install
sylvain legault
Reviewed in Canada on June 10, 2018
Parfait
Customer
Reviewed in Canada on September 9, 2017
installed easy & worked 1st time ...
Customer
Reviewed in Canada on September 8, 2017
fit perfect, worked great.
Hot rodder
Reviewed in Canada on November 28, 2015
worked perfectly, slightly different from the original ones but seem to do the job.
Recommended Products
$30.51
$ 14 .39 $14.39
$113.06
$ 44 .63 $44.63