Your cart is empty.
Your cart is empty.Product Description
AZOR AP01 Pedal Power Adapter
AZOR AP01 9 Volt Adapter
The AZOR 9 Volt Adapter works with any device requiring a tip negative 9V to minimize or eliminate the need to change batteries. It can also be used to power additional 9V tip negative effects pedals.
Not Just for Pedals
The 9 Volt adapter isn't just for powering pedals, it can also be used for other manufacturers' electronics. The adapter can also be used to power tip-negative keyboards.
Magnet Ring
The magnet ring can Reduce noise disturbance. The professional noise isolation performance ensures you a quiet pedal chain condition while you play. absolutely no loss of sound/signal. Smooth sailing and happy shredding!
5 Way Cable Chain
5-way cable chain could power 5 pedals at the same time
Professional noise isolation performance, Tip Negative (-) design
Cables
Reversed polarity cables 2pcs
Battery clip cables 2pcs
Carlie
Reviewed in the United States on March 22, 2025
So far I've only used it to power 3 things at once. But, one of these days, I'm going to get a wah.I really like having the little 9v battery wire as a backup to my backup. It's a good set.
JTrucker
Reviewed in Canada on September 22, 2024
Nothing much to say. It's power supply. It works as it should. Connected only two (don't have more yet), I can only hope it will hold the power for more...
Fredric Josef Armstrong
Reviewed in the United States on June 19, 2024
This transformer has enough output to run everything I have including some pretty high-draw pedals. Low cost solution for battery elimination or small pedal board. Nice that it comes with a few odd dongles.
William L.
Reviewed in Canada on January 27, 2024
Provides good connection without any drop on power. No static noise. Good price. Powers all pedals without issue.
Jonathan R. Garcín S.
Reviewed in Mexico on September 13, 2023
No se calienta ni mete ruido al sonido.El cable del eliminador es algo corto en comparación con otros.
J. Reveley
Reviewed in Canada on July 1, 2023
If you're using more than two but less than all the plugs you have a bunch of hot barrels dinging around. Don't ground them to the case of a pedal!
Curt Barrett
Reviewed in Canada on December 13, 2023
Very versatile at an affordable price. Little or no buzz noise. If you would like covers for the unused adapters, a 3/16-inch heat shrink tube cut into 1-inch pieces ( do not heat ) fits snugly enough to be removed as needed. Enjoy the music.Curt ( Newfoundland )
iReview
Reviewed in Canada on October 28, 2023
Guitar pedals use reverse DC polarity so not just any DC adapter will work. Even my "universal" adapter didn't work.It worked fine when I tested it with four pedals at the same time. If you just need to power one pedal you can take off the daisy chain connector. There are four extra adapters which I never got a chance to use, one of them is a reverse polarity cable. And it's relatively inexpensive so I can say that I would recommend it.
popop
Reviewed in the United States on May 20, 2020
This works great. I don't need the 8 plugs but it works for the length. The wire out of the transformer is 45 inches long. The wire with plugs is 80 in long (10 in between each plug) I measured volts and its a little over 9v. Didn't measure volts under a load though. I use this for a keyboard that needed a negative tip. Great value.
TKM
Reviewed in the United States on July 4, 2019
Was a little concerned these (I bought 2) might be noisy, but I’ve been very pleased with these so far. I don’t have a fully isolated PSU for my pedal board, mostly because it’s already quiet for the most part. I do have a couple pedals in the loop that cause noise on a daisy chain though, so I’ve simply put those on their own power supply. Now everything is as quiet as it should be. It’s still a pretty simple setup...One power supply for everything before the amp, and one for everything in the loop.
Recommended Products
$11.99
$ 5 .27 $5.27