Your cart is empty.
Your cart is empty.Counteract Balancing Beads for motorcycles provide an automatic, readjusting, trouble-free, lifetime balance of the tire and complete wheel assembly for all wheel locations. When Counteract Balancing Beads are installed inside the tire the specially coated micro-spheres are distributed throughout the tire through centrifugal force as the wheel rotates. As the force of the out-of-balance spot increases and pulls the suspension in an up and down motion, the inertia causes the beads to move in the opposite direction and rapidly shift until complete wheel assembly is balanced. Counteract Motorcycle Beads are a replacement for wheel weights, just install and go! Extends tire life, decreases vibration, lasts for the life of the tire, provides the smoothest ride possible. MOTORCYCLE BEADS ARE DIFFERENT THEN TRUCK BEADS, COUNTERACT DOES NOT VALUE ANY WARRANTY IF TRUCK BEADS HAVE BEEN USED IN ANY MOTORCYCLE APPLICATION.
Hal Arthur
Reviewed in Canada on March 3, 2025
Changing a tire is not as easy to do as you might think but this makes it easy to take off the old tire and slide the new one on but you need a lot of the stuff to make it easy and try not to get it on your hands or it makes it hard to handle the tire and rim assembly.
Ron Orzel Sr.
Reviewed in the United States on August 3, 2024
I have used the beads before in my truck so now I do my own motorcycle repairs and ordered beads to use in Nike tires. Well upon watching a tutorial on putting them in the tire I attempted but the beads do not just go in, they get bunched up at valve stem and adding slight air pressure they still won't enter thru valve stem but they blow back out when you remove air supply to force them in. I after wasting an hour or more plus many beads were over the floor I broke the tire bead them put beads in tire reinflates tire and didn't have any issues after that they work food once inside but until then good luck.
Michael S.
Reviewed in Canada on August 2, 2024
Easy and straightforward, seems to be doing what it's supposed to do, I'll buy again
eric fortin
Reviewed in Canada on August 18, 2024
Easy to get in tires and gets rid of vibrations
Kyle
Reviewed in the United States on June 22, 2024
Good value for the money and easy to use. They work well !
RayRay
Reviewed in the United States on November 8, 2024
A little hard o install, but overall does the job very well.
claude langlois
Reviewed in Canada on April 1, 2024
Tel que décrit, livré rapidement, A produit un balancement impeccable du pneu de ma moto. À recommander.
Takenoprisoners
Reviewed in Canada on September 22, 2023
I've seen videos online about balancing beads so bought this kit, its a little tricky to get the beads in the tire using the supplied plastic bottle and short hose, I followed all instructions but it was still awkward, I'm assuming that they work, it didn't say anything in the instructions about just putting the bag in as I've seen in some YouTube videos, so I didn't do that , I didn't know that the bag would break open as shown online, the accessories with the kit were handy but I will start looking around for 'just the beads' as I'm sure there would be huge savings.
Jason E. Young
Reviewed in Canada on June 3, 2023
Use these in both tires and placed into tire tubes. Purchased kit as a spare just in case I get a flat & have to replace my tube. Just takes time to transfer beads from bottle to tire tube. Other than that works as stated. Easier that having to balance tire and have to add weights to rims.
C. J. B. and D. J. B.
Reviewed in the United States on October 14, 2023
Installed these in my Goldwing tires when I changed them, WOW what a difference so much better than lead weights attached to the rims.
Tyke
Reviewed in the United States on August 20, 2020
These ceramic beads work great. My motorcycle ride has smoothed out noticeably and has really increased my ability to ride in the twisties. Some what of a challenge to install. Patience is very, very important. Some guys said to put the valve stem at the bottom and use an air compressor to very lightly blow them in when they clog up. Air - yes, clog up, oh, - hell yes, valve stem at the bottom, no, no, no. They will go in way faster and easier if you place the valve stem about ¼ of the way up. It went real quick after I discovered that. Poor em in and enjoy your ride, your worries are over. I won't ever use lead weights again.P.S. if you spill these, you can't even imagine the places these can roll too.
Customer
Reviewed in Canada on April 8, 2019
So far seem to be working as described, used in tubed spoked wheels. Installation can be tricky, used compressed air with a metal mesh to prevent beads from coming back out the valve.
Recommended Products
