Shopping Cart

Your cart is empty.

Your cart is empty.

Geekstory BE-180 GPS Module Beidou GPS AntennaTTL Level 38400bps for Arduino Raspberry Pi Aircraft Pixhawk APM Flight Controller

4.8 (5) Write Review
Free shipping on orders over $29.99

$16.55

$ 8 .63 $8.63

In Stock

1.ColourName:Blue,green,white


About this item

  • This BE-180 GPS Module using the latest 10th generation chip When you use it for Raspberry Pi, there is no driver needed. Here is connection with RPi, red to 3.3v, black to gnd, green to txd, white to rxd
  • The TX LED flash means gps module output normally. The PPS LED flash means gps module locate your place
  • Data Level : TTL or RS-232, Default TTL level. To make it be RS232 output, you need to use one TTL to RS232 converter cable
  • This BE-180 GPS Module has Flash to save configuration, so you do not need to reset data next time when you use it.. Baud Rate : 4800bps to 921600bps, Default 38400bps
  • What you will get: 1*BE-180 GPS Module; 1*1.00mm 4pins Cable; 1* 20cm 1.0mm 4P Connector Male Cable


Description:
Chip: M10050
Receiver mode: GPS, Galileo, BDS, QZSS and SBAS
Frequency: GPS L1, GLONASS L1, BeiDou B1, SBAS L1, Galileo E1
72 search channel
Baud rate: 4800bps-921600bps, 38400bps by default
Output level: TTL or RS-232, TTL by default
Output agreement: NMEA-0183 or UBX, NMEA-0183 by default
Single: GNSS:1Hz-18Hz
Standard: GNSS:1Hz-10Hz,1Hz by default
Size: 18*18*6.2 mm
Module pin
1.PPS, Sec pulse will output after positioning, pulse period is 1s, high level persists 100 ms, used for system synchronization
2.GND, connect to the ground
3.TX data output of module
4.RX data input of module
5.VCC, 3.0V-5.5V, recommend 5.0V
6.BOOT
Package Includes:
1 X BE-180 GPS module
2 X Cable


Martin
Reviewed in Germany on September 15, 2024
It dosnt have built in battery, as shown in pictures.
Bob
Reviewed in the United States on May 6, 2024
The unit works great, even indoors about 10 feet from a window. At least it did until I applied 12 volts to VCC by mistake and let out the magic smoke. I ordered another immediately .
Alberto Ardit
Reviewed in Italy on May 27, 2024
Utilizzato su drone FPV. Non è velocissimo ad agganciare i satelliti, ma una volta fatto il 3D fix, in volo poi arriva a vederne anche 26/28. Configurato tramite adattatore a 115.000bps e 10kHz.Consigliato.
Luis Caba
Reviewed in the United States on July 4, 2023
Using BF4.4.2: I get 15 satellites after a while of flying. I would like to have more satellites in the cold arm, since they are around 8 sats after almost 7 minutes. But it's to be expected from an M8 chip.
The Toolman
Reviewed in the United States on December 28, 2021
These little GPS modules are great for adding a layer of safety to your race quad. Just hookup to power (3-5V), ground, TX and RX of an available UART on your flight controller then setup in Betaflight and you are ready to go. There are lots of good tutorials on Oscar Liang or YouTube to guide you along. You can program these modules using U-Center using the U-Blox protocol to set a higher data and refresh rate for better accuracy. They are a great GPS for the money.