Your cart is empty.
Your cart is empty. 1.Can be used as a DC12V led dimmer switch for led lights,it is touch sensor switch.And it is Suitable for DC 5V-24V led lights.
2.Mini size and embedded,easy to install and save your place.
3.Just touch the led dimmer switch to control on/off the led strip.So easy.
4. Stepless dimming-Keep press your finger to the led dimmer switch, the led lamp's brightness gradually Change to the maximum. Let go, keep press again,the brightness slowly becomes minimum.
5.Memory function.This led light dimmer switch can keep the same brightness as last time you turn off the led lights.
6.This touch sensor often use as a lamp DC 5V/12V/24V dimmer switch,you can also used for other project.
7.Package included 1piece low voltage light switch(5V-24V)
Aguila
Reviewed in Mexico on March 17, 2025
Un sensor de muy buena calidad y cumple con todas las características necesarias
Kingkongmegatron
Reviewed in the United States on April 12, 2025
Works very well, though it took some time to get used to the sensitivity/operation.
Danny Frisch
Reviewed in the United States on February 4, 2024
After trying to beat this switch to death, I figured it out. Instructions not specific. There are 4 wires coming off the switch. #1-Black wire- goes to battery ground, #2 red wire goes to ignition wire, not battery. #3 red wire goes to lights, #4 yellow wire goes to lights ground wire or wires. It is not an on-off switch. it is only a dimmer switch. On - off requires key on to turn on, and key off to turn off. Hope this helps everyone.
Chris B
Reviewed in the United States on February 25, 2024
I have used numerous of these switches in various projects, both my own and for clients. Was hestitant at first despite from of the reviews. Long short, they work great if you know what you are doing (basic electrical skills and such).I have purchased and installed many of these touch activated switches, from latching (no LED) to latching with LED always on, to stepless dimming (LED on when light on). All have worked from the start and continue to work perfectly. Really great switches.Note that these switches do not interrupt the red (positive) wires as in most mechanical toggle switches, but instead interrupt the black to green connection (negative); in other words, the black and green wire CANNOT share a common ground but must instead remain on separate, isolated circuits (green to battery negative, black to light negative).This is exactly as shown in their installation instructions. However, I tried to take a shortcut with this light as I was swapping out an older, mechanical toggle switch and had wired the light so that its black/negative ground wire was connected to chassis ground, which is also ultimately connected back to my "house" battery ground in my vehicle. The touch switch didn't operate under these conditions (unlike most 12V DC mechanical toggle switches). I have since disconnected the light's ground wire from its connection with chassis ground and connected it directly to the black wire of the touch switch, and viola! All the switches I have utilized work perfectly!I've included the wiring schematic I received.
Customer
Reviewed in the United States on February 20, 2024
I really really wanted to like this switch. Installed pretty easy. It looks and works great until it doesn’t. At less than six months installed, 2 failed within a few days of each other. They are fully on and will not dim or turn off. Such a shame as they are pretty and nice when they work but working and lasting is a minimum requirement.
Recommended Products
