Your cart is empty.
Your cart is empty.Product Description
For a quick fix in a pinch, get this set of pigtail wiring harnesses!
This page features the pair of metal socket base adapters for turn signal and reverse light use as well as retrofitting work. Each pack comes with two pre-wired 1157/2057/7528 socket/base adapters that are compatible with the following bulb sizes:
- BAY15d, 1016, 1034, 1076, 1130, 1154, 1157, 1158, 1493, 2057, 2357, 2397, 7528, P21/4W
Each pigtail socket unit is made up of a durable metal socket that lasts longer than most other pigtails and a heat-resistant nylon base with 4.5-inch pigtail wires. Ideal for retrofitting, repairing or replacing LED or incandescent light bulbs, these metal socket pigtail harnesses give you the quick fix you need to adapt light bulbs and quickly enjoy your fresh new turn signals or backup lights!
High Quality
- 2 pieces pre-wired 1157 socket/base adapters
- Made with more durable metal socket, heat resistant nylon base with 4.5" pigtail wires
The perfect wiring solution for your LED retrofit installation!
K9 Cleanup - Republic, MO
Reviewed in the United States on March 19, 2025
With some basic wiring knowledge you can save yourself hundreds of dollars in mechanic labor fees. My bulbs were completely stuck to my melted sockets and the factory plastic started breaking when I attempted to replace them. This products was affordable and works great.
nick seybert
Reviewed in the United States on November 26, 2024
The Metal Socket/Base with Pigtail Wiring Harness is a durable and reliable solution for electrical connections. It came quickly and did what I needed it to do.
Guess
Reviewed in the United States on October 9, 2024
Before this replacement, I did a prior replacement with a more expensive OE part. This part was short lived, this part is affordable and reliable.
Joe Boyd
Reviewed in the United States on October 26, 2024
The media could not be loaded.
edward ambrose
Reviewed in Canada on May 6, 2023
You can change the socket only and not the entire wire harness.
Joe Consumer
Reviewed in Canada on March 5, 2023
The wiring for my 2013 Elantra GT matched up. It was a little tight to seat so I used the rubber seal from the old light as it was a bit thinner and it worked (rather than file a bit from the tabs). This socket is a full metal case and should last the lifetime of the car unlike the cheap crap that came with the Hyundia. They may have lasted better if the junk rear light lenses themselves didn't leak. (fixed with epoxy).
Stephanie Sampson
Reviewed in Canada on October 11, 2020
Easily installed and so far it works.
Miguel
Reviewed in Mexico on January 27, 2020
Excelente producto, tiene muy buena calidad muy similar al original de agencia, solo hay que sellar las salidas para prevenir la entrada de agua al faro
Recommended Products