Your cart is empty.
Your cart is empty.Uses hook and loop sand paper, for additional sandpaper use Karebac Stearated aluminum Oxide part numbers 66830, 66832, 66833, 66834, 66835, 66836, 66838 through 66841. Perfect for balusters, handrails, wood moldings, Countertop edges and many other applications. Karebac makes a full line of abrasives for the automotive, woodworking, marine, glass & Marble Industries. We also carry a line of tools to be used with our common products. Our innovative designs are the perfect start to the perfect finish. All products are 100% satisfaction , see manual for information.
Patrick E.
Reviewed in the United States on August 11, 2023
Finally found the time to use this and was super excited because I’m refinishing a set of teak furniture…At first it worked great but then it just stopped and air is coming out but no action.. tried shaking it because I have a feeling it’s the cylinder that’s not working…So works great when it works but didn’t work for long unfortunately
Bruce
Reviewed in the United States on July 21, 2022
My project (well, FIRST use...) is a 1976 Alfa Romeo Spider - with lots of curves and grooves. This sander is ideal for those "blood grooves" down the length of the sides, and the headlight tunnels. You can pick from a wide variety of curves amongst the blocks, slap it on the power head and add your appropriate weight of paper (all hook and loop attached). Roll sand paper with hook-and-loop backing works great.Operation is fairly low air usage, and "just right" when adjusted for speed (air flow knob).Price seems fair.
jeff
Reviewed in the United States on July 16, 2020
Previously submitted one star review due to difficulty getting the device to run. Seems to need to be shaken so piston inside is setting just right before it will oscillate, otherwise, just sat there hissing, and no amount of pushing/pulling on pad would coax into motion. Finally discovered it needed to be shaken a bit each time I picked it up to use it.Left message with seller a few weeks ago. No response. Suddenly, today, I'm told a new one is being sent as a replacement, and I could simply send old one back in same box. Will see how replacement runs and report back.Must address - another reviewer had problems with velcro. Not sure why - there is one style of it to adhere specially shaped pads to the sander, and another on the face of the profile pad for sticking sandpaper to. I had no problem with either one.When it runs, it does do a good job of sanding cross-grain wide - belt sander pattern on doors and face frames. (no trim profiles yet) Seems a little faster than random orbit, which I still use for a quick, final sanding prior to finishing.
Allen
Reviewed in the United States on April 21, 2020
This is a great little tool to have if you sand anything with contours! I haven’t had it long but have already used it a lot! I repair boats and the lines in them can get pretty busted up rebuilding them takes time and this tool saves time! Well worth it!
Richard S. Fay
Reviewed in the United States on December 15, 2018
This is a good tool. I had 39 hardwood cabinet doors with bead profiles to sand and refinish. This straight line profile sander was a hand saver. The tool is quiet. Vibration and noise level is significantly less than my electric sanders. My only question is why didn't I have one of these years ago. If there was a source for the tool only without the profile set, I'd likely buy a couple more. The velcro pad holding works so well that the pads can be a little tough to change. Not a complaint but I'd rather have multiple tools already set up. This was one of those great purchases.
Recommended Products
CA $161.10
CA $ 65 .99 CA $65.99