Your cart is empty.
Your cart is empty.Product Description
Specification:
Type: MOTOALL Carburetor Carb for Yamaha MZ360 EF6600 Engine Motor Generator EZ-MZ360-00CM
Color: As the Pictures Show
Fitment Type: Direct Replacement
Part Number: EZ-MZ360-00CM
Premium Type A for Yamaha Gasoline Engine MZ360 Replacement
Carburetor Assembly without a Solenoid.
Carburetor with gasket Assembly Replacement For YAMAHA MZ360 Engine
Package Includes:
1 x Carburetor, 2 x Gaskets, 1 x Fuel Line with 2 Clips, 1 x Spark Plug, 1 x air filter, 1 x oil filter, 1 x Fuel Valve Switch
Note:
Please compare the product pictures with your old parts.
Make sure the part numbers match and the models are compatible before you buy to ensure you get the right and correct carburetor.
Mark and Nancy Burke
Reviewed in the United States on February 20, 2025
Exact replacement and runs the engine well. The only issue was the gasket bolt holes were smaller than the carburetor studs on my engine.
David Warren
Reviewed in Canada on April 5, 2025
Well it worked somewhat. Maybe it needs to be set up but I have not the knowledge to do that. I will make a second attempt to tune it up to see if my generator can run better . But on the bright side, I was surprised on all the gear that came with it, gas line and filter, even the air filter that fits my generator, gas lines and gaskets. I was surprised. But needs a fine tune. My generator doesn’t run good.
Barry2b2
Reviewed in the United States on August 9, 2024
it started up ok, but would not idle, and would lean out, I checked the richness adjustment screw on the right side, and it was screwed in tight, I backed it out 1.5 turns counter clockwise, and then It would run with no choke and idled ok, quality seems good, some brass,
Kindle Customer
Reviewed in the United States on July 20, 2024
I replaced the carb on my rigid 6800 watt generator with this one and have to say that it was very easy and straight forward. The generator ran on the second pull. There was a slight bit of surging at first but that went away after replacing the air filter. All in all it is a good product at a very reasonable price.
DanO
Reviewed in the United States on March 15, 2024
Not only a ferfect fit , there were NO adjustments needed. Older Rigid 6800 generator piston was rusted to a locked condition and the float bowl was full of rusty sludge. I free'd the piston, cleaned the bore, put on this carburetor , pulled the chord twice and it came to life running smooth and at the propper RPM.
Customer
Reviewed in the United States on November 8, 2024
Installed it on my Generator which had not been used for 7+ years, and she fired straight up (previously refused the fire). Well built product and for the price, came with all the options I needed. The filter came in handy as the old one was starting to perish.
Recommended Products