Your cart is empty.
Your cart is empty.Product Description
519-CCB2206L
About NICHE
NICHE specializes in the highest quality Powersports replacement parts. Our parts meet or exceed the quality of the original parts that come with your machine. Some of the NICHE product categories include cylinders, brake pads, axles, off-road mirrors, and drive chains. Let NICHE components fix your machine today!
NICHE Rear Hand Brake Cable 519-CCB2206L
Cable Type: Rear Hand Brake Cable
- Includes: Rear Hand Brake Cable
- Compatible with the following brands: Yamaha
- Compatible with the following models: YFM 350FW Big Bear 4WD,YFM 400FW Kodiak 4WD
- Replaces for the following OEM MPN's: 05-0240,4WU-26341-00-00
Cable Comparison
Clutch Cable
What is it?
- A clutch cable allows the vehicle to change gear
Why Replace?
- They break, the constant stress of the cable sliding in and out causes a break at one of the end.
- The cable casing gets damaged due to being close to moving parts, damaged housing causes the cable to bend and corrode.
When to replace?
- A common sign that your clutch cable is damaged and needs replacing is if the clutch lever is stiff or your gear shifts aren’t smooth
Throttle Cable
What is it?
- The engine of your bike needs air and fuel to run. When you turn the throttle, it connects to the pull cable and pulls open the butterfly valve. This allows air to enter the intake manifold
Choke Cable
What is it?
- A choke cable is designed to restrict the flow of air in the carburettor of an engine
Choke Facts
- There is no harm using the choke to start an engine. When it’s cold, it can be a necessity to get started
- Using it a choke will only lead to increase fuel usage, but no damage to the vehicle.
Pull Throttle Cable
What is it?
- This is the cable that pulls open the valve when you turn the throttle. It allows air to get into your engine
When to replace?
- You should replace your throttle cables after three years or 10,000 miles
- If a cable breaks, frays, or you change your handlebar you will need a different cable as well
Push Pull Throttle Cable
What is it?
- A dual cable throttle operation where the pull cable opens the throttle plates, while the push cable, along with a throttle return spring, closes the throttle plates
Installing Tip
- When installing a new cable, make sure to note the routing of the original cable. Also, the dimensions of the new cables must be identical, allowing for the fact that old cables do stretch over time.
Maintenance
- After a race or as often as possible after washing to remove the cables from the bike and flush them through with a blast of air. Also the nipples can also be lubricated, with copper grease
Push Throttle Cable
What is it?
- The push cable is a safety addition, there is a spring that will close the valve whenever the throttle isn’t activated but if the spring fails the push cable safely closes the valve.
When to replace?
- You should replace your throttle cables after three years or 10,000 miles
- If a cable breaks, frays, or you change your handlebar you will need a different cable as well
RTU
Reviewed in the United States on July 8, 2024
I typed in what I was looking for and this one popped up at or near the top. It wasn't the same length as the OEM cable. 4" shorter. Fortunately I'm smart enough to re-route it and make it work. After I got it on, I looked at the description and it doesn't say for a 2003. So word to others, check that description before you push that purchase now button. Don't ASSUME it's the same as OEM.
sylvain brisson
Reviewed in Canada on November 14, 2024
Fits good..works good
Robert W.
Reviewed in the United States on November 1, 2024
Absolute perfect fit gave new life to the stretched out factory cable. Perfect fit, good quality, I can’t recommend enough.
Brian b
Reviewed in the United States on August 1, 2023
Great quality, perfect fit, fast shipping, $50 cheaper then oem.
Serge Leblond
Reviewed in Canada on May 30, 2023
Perfect
Recommended Products
$31.74
$ 13 .57 $13.57
$25.55
$ 11 .31 $11.31