Your cart is empty.
Your cart is empty.ASIN SKU 585056901
Client d'
Reviewed in Canada on March 11, 2025
Article répond exactement a la description .Merci
Customer
Reviewed in Canada on January 19, 2025
Old one came out new one fit in, 10 minute job
Nanaberr
Reviewed in Canada on January 18, 2025
Exactly what the guys needed to fix snowblower
R.M.Lee
Reviewed in Canada on April 8, 2025
appears to be good quality
Customer
Reviewed in Canada on April 13, 2025
Works as advertised
minato
Reviewed in Canada on February 8, 2024
It worked great. No sellers around here could get it, this item really saved us
Kindle Customer
Reviewed in the United States on December 27, 2024
Price was right and solid part and faster delivery then local Huskie blower repair shop Thank You !!
Bill W
Reviewed in the United States on November 5, 2024
I have put this on my snow thrower and it fit just fine. Holes lined up etc. The original cracked and broke after 3 winters - probably from rocks being picked up and shot through. This part hasn't gone through a winter yet so I will probably know a lot more in a few months. This fit on my Husqvarna snow thrower.
Gerry D.
Reviewed in Canada on January 2, 2024
The part was difficult to install due to the poor fit and finish. I question the reliability of the part due to the stress on the product caused by the poor fit.
Jordan
Reviewed in Canada on January 15, 2024
Works as intended. Much better price and arrived faster than what my local dealer offered.
ENF
Reviewed in the United States on December 1, 2023
Husqvarna ST227P - Chute Base replacement procedure. 1st - remove one nut 14mm holding the chute neck to bracket and move the upper chute out of way. 2nd - remove two 3/8" bolts holding the belt cover on and remove belt cover. 3rd - remove four 12mm nuts and bolts holding the Chute Discharge Base. Note: When you remove the bolts, you can reach into the opening of the chute base and hold the bolts in place, so they do not drop when you take off the nuts. The two bolts and nuts that are located toward the middle of the snowblower on the chute discharge base have a metal plate that is held from inside the auger housing that the bolts feed through before coming up through the holes in the auger housing, so when you remove those two bolts remember that they have to go back through that metal plate first when reinstalling the new chute. Now just reverse the procedure to install the new Cute Discharge base. It took approx. 20 minutes to remove and replace the chute base and that includes cleaning up the tools and moving the snowblower back in the barn.
Herb T
Reviewed in the United States on March 15, 2021
This part was to replace a discharge base on my Husqvarna snowblower. The part fit perfectly and has functioned as required. The shipment and delivery were as advertised. Great parts service.
Steve Peet
Reviewed in the United States on May 4, 2019
Parts fits my snowblower, although the bolt holes are slightly too close together to make for an easy fit. Otherwise, this is exactly what I needed.
Recommended Products
CA $19.48
CA $ 9 .99 CA $9.99
CA $29.47
CA $ 14 .99 CA $14.99
CA $37.89
CA $ 19 .99 CA $19.99
CA $119.99
CA $ 52 .99 CA $52.99