Your cart is empty.
Your cart is empty.The legend
Reviewed in Canada on March 12, 2025
Great tool, bought it for doing atv axles
Caleb
Reviewed in the United States on March 12, 2025
Seems to work just fine, still haven't used the gloves. Great clamp tool.
Lisa
Reviewed in Canada on February 27, 2025
had to replace CV boot and got this tool. The tool is very simple to use however you i found that you need to keep pressure down on it for it to work properly, I ended up using the plier tool to finish the rest of the clamps, it was defiantly easier to use on the larger clamps verses the smaller ones on the shaft.
jfrank1961
Reviewed in the United States on February 27, 2025
This tool worked exactly as expected. I added some anti-seize to the threads to ensure smooth operation for future use.
WM
Reviewed in the United States on February 26, 2025
Don’t buy the plyers, buy this. Much easier to use and frees up both hands.
Rickster
Reviewed in Canada on January 12, 2025
Im satisfied with this tool and used it a few times already. It did a great job with closing the clip and im certain iwill have many more uses in the future. Your money will be put to gooduse buying this tool
Andrew
Reviewed in Canada on April 2, 2025
Works exactly as described
Cesar a.
Reviewed in Mexico on July 21, 2024
Está hecho de un muy buen material, cumple su función. Por tanto facilita mucho el trabajo, más que las pinzas que son para lo mismo.
Muy eficiente herramienta, me funcionó muy bien
Reviewed in Mexico on May 4, 2024
Reparé unas polveras en un auto Corolla y funciona perfecto.
Tracy I.
Reviewed in Canada on December 1, 2024
Needed this for my CV Boot replacement on my Toyota. Worked as described and looks factory, for a reasonable price.
M F
Reviewed in Canada on April 10, 2024
2011 Toyota Sienna CV boots. I purchased the OEM CV boot kit with clamps.Pros: This tool tightened the clamps easily and correctly. I was surprised how little force was needed with a 13mm box end wrench on the tool bolt. The clamp crimp looks just like it was factory installed. I tightened the RH inner boot after I installed the axle onto the cross shaft so I wouldn’t have to deal with that nasty cross shaft bearing. There isn’t a lot of room but the tool fit in the space no problem. Tool is made of good quality material. No sign of fatigue or wear after eight clamps, and should last indefinitely for a DYIer.Cons: The two set screws that hold the jaws are loose and could be a problem with jaw alignment if they get too loose. I used thread locking fluid on both screws. On the jaw opposite the bolt, I tightened it completely against the stopper, because this jaw doesn’t need to move when clamping. On the other jaw I set the screw so the jaw would slide with very little play. Now both jaws stay aligned. The bolt threads and jaw sliding surfaces were dry, so I lubricated all moving parts. The bolt looks like any off-the-shelf bolt with an unfinished and rough end. I could see it digging into the jaw as the bolt was rotating which caused friction and damage to the jaw. I sanded down the end of the bolt so it is smooth, square, and flat and added some lube. Now the bolt rotates smoothly.Conclusion: The mods didn’t take long and are easy to perform. If the manufacturer had done these mods, it would have received five stars. After these small mods, the tool performed very well and I do recommend to any DYIer.
Recommended Products