Your cart is empty.
Your cart is empty.Product Description
Dave
Reviewed in the United States on November 15, 2024
The XMR rock rail is in the way on the rear bottom fender but nothing a little trimming won’t fix. Other than that they went right on. The holes lined up with the stock fender flares. I used the screws from the stock flares to install the extended flares on. Well worth the time and effort to keep from getting mud thrown on your face/arms. The bottom rears do attach a little different. They require a few holes to be drilled and held in place with plastic push lock plugs.
Customer
Reviewed in the United States on October 28, 2024
Good fender flares, the rear fender flares are way too wide
Spencer
Reviewed in the United States on April 1, 2024
Very good product, very easy install
Canadian guy
Reviewed in Canada on September 5, 2023
the front ones fit fine and were the proper width for my 2023 canam defender HD10, th rear flares are way, way too wide and look ridiculous, i needed to buy 1.5 inch wheel spacers to make it look half ok.they need to sell this kit with the narrow front flairs
DwaynePaskell
Reviewed in Canada on September 22, 2022
A Little hard to install but not too bad
Sideup
Reviewed in the United States on September 3, 2021
Easy install. One suggestion if you have the tool use riv nut inserts on the middle flare in front of rear wheel to avoid using the machine screws and nuts in hard to access area. Also use rivnuts inserts at the bottom instead of the supplied rubber expanding insert. The rubber insert is too weak and will not hold. Other than that the front and rear sections are super easy to install.
Nathan Newman
Reviewed in the United States on June 3, 2021
Instructions that came with these are CRAP! No good Instructions or videos online either. My son and I installed these last weekend. Thank goodness, between the 2 of us, we figured it out. The front still doesn't look quite right to me. If there were clear instructions on how and where to line them up, it sure would have been helpful. I guess that's what happens when you order trash products from overseas because they are cheaper. Will see how they last!
Lorne d
Reviewed in Canada on March 29, 2021
Looks good. Fits great. Easy to install except the lower rear section. That takes a lot. Also don’t drill all the pre drill dots in the lower rear section. The top hole needs to be drilled just below the pre drill spot. Place that lower back section on the unit and mark all the holes manually. This is not in the instructionsBe very careful with the bottom hole as it uses a rubber squish nut that can easily strip out. The hardware is simple steel that is poorly coated. I will see how it lasts for rust. Might change them out for stainless steel. All in all it shipped fast fits good and looks factory. I would recommend this kit.
Recommended Products