Your cart is empty.
Your cart is empty.Product Description
What do you need
- A new strap
- Wrenchs and sockets at the right dimension
- A box cutter
- A wire brush
- A rag
- WD40 or other lubricant
1-Buy the right strap
It may not have been obvious to you, but not all straps are the same. There are several widths (usually 2’’ and 3’’), lengths (depending on the length of the trailer) and especially load capacities. Be sure to choose a model that offers a maximum breaking load at least 20% greater than the weight of your boat, it is insurance for your safety.
Regarding the length, do not take one that’s too short, obviously, but also not too long, because the strap will not fit in the groove provided for this purpose.
2-Remove the old strap
Just unroll the old strap all the way, being careful not to get your fingers caught.
3-Loosen the central bolt
The strap is held in place by a central bolt. It may be the bolt acting axis or another slightly offset. Loosen the nuts of the bolt with two keys. It is possible that the nuts will resist a little because of the corrosion. In this case, use a product like WD 40.
4 -Remove the central bolt and inspect it
Once the bolt is unscrewed, remove it from the winch and remove the strap. If the strap is too old, you may need to cut it with a box cutter at the shaft to remove it. Inspect its shape. It must not be twisted or attacked by corrosion. If it looks bad, it’s better to change it.
5-Do some cleaning
Once the bolt is removed, clean the winch cage and make sure there is no corrosion. If the galvanized coating is a little damaged, you can spray some cold galvanizing. Perform the same operation for the center bolt.
6-Install the hook
Most straps are sold with a new hook. If this is not the case, do not forget to insert the hook into the loop of the strap. Be sure to follow common sense by keeping the strap flat.
7-Install the new strap
Insert the bolt into the winch cage and at the same time slide the bolt into the loop sewn at the end of the strap. Tighten the nuts of the central bolt without tightening too hard, because the the axis needs to remain mobile.
8-Wind the new strap
Wrap the new strap onto the winch drum using the crank. Make sure the strap winds neatly, staying flat and without wrinkling.
9-Hang the strap on the boat
Before you finish winding the strap, do not forget to hang the hook onto the boat’s ring. Wind it until it is tight and make sure that the winch locking pawl is working properly.
10-Finish by lightly greasing the winch
While you’re there, spray a little lubricant on the mechanical part of the winch, it will be easier to handle.
11-Pay attention to the load
Finally, there is normally a place on your winch where your workload capacity is indicated. If necessary, you can refer to the manufacturer’s instructions. Finally, do not replace a cable with a strap, the winch is not designed for this change.
mike
Reviewed in the United States on April 13, 2025
Very strong great replacement
Maverick
Reviewed in the United States on September 9, 2024
works well and very easy to install. The first one we ordered was too long so always check what length you need.
Ken
Reviewed in the United States on June 14, 2024
Strap was as perfect for my boat.
Courtney
Reviewed in the United States on May 23, 2024
Perfect fit for my 17ft boat. Strap had broke got a new one the next day. Easy to install. Great price. Also had the clip on end of strap to lock it on to boat. Looks strong
Marlene MacIntosh
Reviewed in Canada on October 17, 2024
In a boat
brad
Reviewed in Canada on August 10, 2023
good product at a good price
Tina M B
Reviewed in Canada on July 24, 2023
Met our needs - a good purchase
Michael Robinson
Reviewed in Canada on June 23, 2023
Very easy to install with a loop on each end and one end with a spring lock hook. If it was any easier, it would install itself. ;)
jean kaufmann
Reviewed in the United States on December 23, 2023
Needed a strap to pull a blowup dingy onto a trailer. This works great and is more than strong enough.
hautcoeur
Reviewed in Canada on October 24, 2023
Ça belle étaient fait ce que je voulais en faire pour mon bateau de pêche..très satisfait
Jessica p
Reviewed in Canada on January 16, 2023
Original one snapped and needed a replacement. Saw this one and so far so good. Put on since July 2022
Customer
Reviewed in Canada on January 8, 2022
Looks good so far- same material as oem strap that came with trailer
Ron
Reviewed in Canada on September 13, 2021
It was exactly as shown and what i ordered, used on a boat winch and worked perfectly.
Recommended Products