Your cart is empty.
Your cart is empty.Used for threading a drilled hole manually at one machine location, without actually moving the work piece. Tapping accessory for drill presses & lathes. Hardened & tempered jaws. Ensures identical centerline of the tap & the drilled hole. Capacity 1/4" to 1/2"
scott g.
Reviewed in Canada on January 15, 2025
A 1/2 tap does not fit in this as advertised.Did not work for my application
Spruce
Reviewed in the United States on September 26, 2023
This is a great tool in it's craftsmanship but it lacks in proper functions. The taps don't stay straight or in the vise. Great for use as a screwdriver chuck.
Victor Rodriguez
Reviewed in the United States on August 2, 2022
I LIKE THIS PRODUCT, USE IT TO GET A KNOCK SENSOR OUT WITH NO PROBLEMS...
JD II
Reviewed in the United States on May 16, 2021
Good.tap wrench. Does not hold straight very well in a drill press, but it.is a good tap wrench.
MRJT
Reviewed in the United States on June 29, 2020
This little gem allows me to chuck it up in my lathe's tailstock or in my drillpress when getting a tap started absolutely straight is crucial. Well done, youse guys.
Rod S.
Reviewed in the United States on November 6, 2020
Works great would recommend a flat edge on the spindle post so when you tighten the small lock screw down it will not twist.
Recommended Products
$7.58
$ 4 .31 $4.31