Your cart is empty.
Your cart is empty.Product Description
-
Transmitter
1. OLED display
2. Power button
3. Parameter adjustment button
4. 5V USB-C charging port
-
Transmitter Display
1. Power / Signal status
2. Transmission frequency
3. Volume parameter
4. Transmission mode
-
Receiver
1. Power button
2. 5V USB-C charging port
-
Receiver Display
1. Power / Signal status
2. Transmission frequency
Main Body of M1 UHF Wireless XLR Transmitter and Receiver
Features
No More Wires
Abandon the traditional messy wiring and make your presentation more flexible and free!
OLED Display
Display your connection status, allowing you to monitor device status clearly, and make your performance more confident.
20 Frequencies
You can simultaneously use 20 sets of M1 UHF wireless mic XLR transmitter and receivers without interference.
Two Additional Connectors
Includes multiple XLR to 1/4" connectors and 1/4" to 1/8" connectors, suitable for a wider range of occasions.
Compatible Partial Devices
M1
Wireless Mic System
| | Rechargeable Battery | |
UHF | Working Frequency | UHF |
20Hz - 20kHz | Frequency Response | 40Hz - 20KHz |
24-bit / 48KHz | Sampling Rate | 24-bit / 48KHz |
110 dB | SNR | 95 dB |
< 5ms | Delay | < 5ms |
| | Rechargeable Battery | |
UHF | Working Frequency | 5.8 Ghz |
20Hz - 20kHz | Frequency Response | 20Hz - 20kHz |
24-bit / 48KHz | Sampling Rate | 24-bit / 48KHz |
110 dB | SNR | >140 dB |
< 5ms | Delay | < 5ms |
- M2
- M7
K. S.
Reviewed in Canada on March 23, 2025
Receiver stopped working after few hours of use
Randy L. Smith
Reviewed in the United States on September 28, 2024
These seem to work well enough for what I needed them for (occasional DJing for friends). The only issue is the power button is not recessed so they are easily turned on/off by accident. Aside from that minor issue, the sound and range are good.
DJ Magic Moe
Reviewed in Canada on July 21, 2024
Didn't last long. I was using this transmitter as backup. After a month of average use it won't even turn on anymore. Sound quality isn't great but because it was a backup I overlooked the minor hissing Sound. It's a total waste of money.
Greg Wiens
Reviewed in Canada on June 8, 2024
I had high hopes when I purchased two sets of these. Out of the box, it was promising, as the quality of sound was "ok". You do hear annoying buzzing, magnified if you have 2 plugged in side by side. Note to those buying more than one: they were set to the same channel so you'll get a loud, obnoxious noise when trying them at the same time. You'll have to change the channel to another for the second set, manually. Not super easy instructions but managed to figure out.Now I am down to one set, as the screen crapped out of one receiver so it's deemed unusable. There's no way to tell what's going on. It let's out a max volume shriek noise as it must not be in sync with the transmitter channel anymore, perhaps from an accidental, blind push of a button, but who knows since you can't see on screen. With it being blank, I cannot tell what's what. Cheap quality is what I get from this experience.Might be worth buying a reputable brand for this sort of thing, especially since they offer no support that I can see.Buy 2, so hopefully you have at least one working after 3 months is my advice.
Chucker
Reviewed in Canada on March 22, 2024
Like the simplicity of use. Plug and sing. No fuss no muss.(ie.cord)
Tee kay
Reviewed in Canada on February 16, 2024
My experience with the STRICH M1 has been a rollercoaster of frustration, primarily due to its abysmal connectivity performance. While the system promises UHF wireless technology for reliable connections, it consistently falls short of expectations.The most glaring issue is the frequent and unpredictable breaks in the connection between the transmitter and receiver. Even in environments with minimal interference, the system struggles to maintain a stable signal. This has resulted in numerous disruptions during performances, leading to a highly unprofessional and unreliable user experience.The wireless XLR transmitter and receiver, touted for their convenience, have proven to be more of a hindrance than an asset. The dropouts in connection not only disrupt audio transmission but also create an audible interruption that is distracting for both performers and audiences alike.Attempts to troubleshoot the connectivity issues by adjusting frequencies and positions have yielded minimal improvement. It's disheartening to invest in a wireless microphone system that consistently fails to deliver on its fundamental promise of reliable and uninterrupted audio transmission.Additionally, the build quality of the components leaves much to be desired. The construction feels flimsy, and I have concerns about the long-term durability of the system.In conclusion, the STRICH M1, despite its potential, falls short due to its unreliable connectivity. For any performer or user who depends on a consistent and seamless audio experience, I would strongly advise looking elsewhere for a more reliable wireless microphone system. The frustration caused by the frequent connection breaks overshadows any convenience the system may offer.
Jane
Reviewed in Canada on December 5, 2024
Good reception, decent sound quality and good value! Highly recommended!
IveTechMedia
Reviewed in the United Kingdom on December 12, 2024
The product as described should offer very high audio quality with 48KHz/24bit sampling and 20-20kHz frequency response. As noted by another reviewer the frequency response is very poor and certainly not high quality. To 6kHz the response is reasonably flat. However, at 10 KHz it is 6db down and between 10-20kHz there is very little signal. All other aspects of the device seem to be OK but this is a rather fundamental failure, Would assume it's a faulty product but because another review reports the same issue, not sure if it's worth trying a second one.
shadowfox
Reviewed in the United States on October 29, 2024
The Transmitter and Receiver work very well however, I did have to correct my review as this model 'does not' have Bluetooth and that's a good thing. it's one less thing to worry about some random board person trying to connect to Blutooth and goofing around. I am happy with my purchase.
Steve tech
Reviewed in Canada on January 30, 2024
I have used this to convert a wierd shure sm58 mic wierless,I have used this to convert a podium mic with phantom power (48v) wierless,And I have also used this product to send wierless audio from my mixer output from a venue ballroom to the lobby with a pro powerd JBL speakerI've had no issue with drop in sound, no issue with change in sound,No issue with loud hissing or unwanted nois.Make sure the frequency matches 100% between Tx and RxKeep the volume set to 5 on both units and use a mixer to adjust main volume.Choose the proper setting betweenmic, 48v, and music based on what you are using it for.
Greg King
Reviewed in Canada on April 9, 2024
Just received and haven't had a chance to really use it but everything seems fine. I particularly like the level indicator on the receiver. I bought an initial pair: one to connect a mic to my board and a second to send from the board to a powered speaker. This is where I ran into problems changing the channel on the second unit. The printed and online instructions are incorrect. The first step should be "Turn on receiver and place more than 15 cm away." The second step says "press the power and '-' buttons on the receiver." There is no '-' button on the receiver! It should say "press the power and '-' button the transmitter." One final note is that the FM interface is really fast, you have to quickly press the '-' button to change frequencies otherwise it goes into pairing almost immediately. I will be buying more to add additional wireless channels to my board with the goal of creating a completely wireless system (the board can be run off of batteries.)
My two cents
Reviewed in the United States on December 25, 2023
No issues to report. Works great for making my microphones wireless for running sound for wedding/live gig events.Works great for my ekit sound module’s output to mixer. Gonna buy more. Frequency response good and distance is no problem.Battery has not crapped out during any event…charge up before event, retains power well when not used.I still have to test it with the active monitor/pa cabs but expect it to work great.
Kindle Customer
Reviewed in the United States on November 11, 2023
Using dynamic microphones these units worked just fine. I tried to use them with two Octavi MK-319 microphones and neither would work. When I measured the phantom output voltage, it was supposed to be 48 Volts DC but I measured it on two different meters at 17 Volts DC. If you need an XLR wireless unit with 48V phantom power these are not for you. All other aspects of the units have since be retested and they are excellent. Good battery life , good range, low noise and eas of operation.
Recommended Products
$373.68
$ 71 .28 $71.28