Your cart is empty.
Your cart is empty. Morse Taper Drift for Morse Taper MT1 and MT2 Lathe Drill Sleeves Carbon Steel
Feature:
High hardness, high toughness
After quenched, not easy to broken
Replace directly, easy to use
Specification:
Material: This morse taper drift is made from carbon steel
Hardness: between HRC48-53
Use for morse taper shank MT1 and MT2
Cone length: 107mm; cone width: 5mm
The total length: 140mm; handle width: 20.5mm
Weight: 76g
Package content:1pc morse taper drift
Chris
Reviewed in the United States on September 27, 2024
I lost my original one and this is a great replacement fir the wen 4214
V. McMullin
Reviewed in the United States on July 19, 2024
Drift came as advertised. I haven't used it yet but expect no problems.
SR
Reviewed in the United States on December 6, 2024
Correct size, used for removing chuck from drill press. It arrived sealed, lightly oiled, and rust free.
Rick's Auto Repair
Reviewed in the United States on November 16, 2024
Works great
OZ4
Reviewed in the United States on April 26, 2024
This MT drill sleeve is a little on the small/short side. It works but in some cases and depending on the bit I'm using, it barely taps the bit out. So far so good.
Kelvin
Reviewed in Canada on December 20, 2023
Works as described
Recommended Products
$11.50
$ 5 .75 $5.75