Your cart is empty.
Your cart is empty. MT3 to MT2 Morse Taper Adapter for Lathe Milling
The Reason Choose Us:
•Morse taper reducing sleeve made of good quality 40Cr/42CrMo Which is high hardness, good rust resistance long durability.
•With high accuracy, inside and outside are very smooth, great performance, long lasting time.
•Directly replace your original perfectly, easy to install for everyone.
•The morse taper adapter wide use for lathe machine grinding machine milling machine and drilling machine etc.
Specification:
Material: This morse taper adapter is made from 40Cr/42CrMo
Bore Diameter: 17.7mm/0.69", External Max.Diameter: 24mm/0.94"
Hardness: between HRC48-53
The accuracy: 0.02mm
The total length: 65mm/2.56inch
Weight: 107g
Package content:1pc MT3 to MT2 morse taper adapter
Note:
The morse taper sleeves we provide are for MT2-1, MT3-1, MT3-2, MT4-1, MT4-2, MT4-3, Please pick what you need.
J. Mike Martinez
Reviewed in the United States on August 20, 2024
Very good quality. Had to get it so I can use a smaller adapter and voila.
David M
Reviewed in the United States on May 6, 2023
Got this for my rotary table. Fits good. Very happy.
Customer
Reviewed in the United States on February 6, 2023
Looks to be good quality, ground and polished inside and outside. Fits right
Bill
Reviewed in the United States on December 13, 2023
I measured TIR on both OD and ID by inserting it into the bore (female MT3 taper) on the spindle shaft of my lathe. OD measured within 0.001" using a "last word" indicator but ID showed TIR of in excess of +- 0.004" which varied along the depth. My thoughts are that the MT2 reamer used to cut the ID taper was worn out or the grinder moved during final finish. I suppose you get what you pay for.
Michon R.
Reviewed in the United States on September 20, 2022
work as needed but sure can be hard to remove. need some kind of tool that is a tighter fit to try and remove as the sleeve is hollow
Recommended Products
