Shopping Cart

Your cart is empty.

Your cart is empty.

uxcell Silicone O-Ring, 4mm OD, 1mm ID, 1.5mm Width, VMQ Seal Rings Gasket for Co2 O Ring, Red, Pack of 50

Free shipping on orders over CA $49.99

CA $5.99

CA $ 2 .99 CA $2.99

In Stock

About this item

  • [Size] - 4mm Outside Diameter, 1mm Inner Diameter, 1.5mm Cross-Section Diameter
  • [Hardness] - 50 Durometer (Shore Hardness) for resistance to penetration
  • [VMQ] - Standard silicone with a wide temperature range from -22℉ (-30℃) to 392℉ (200℃)
  • [Application] - Can be used for travel mug cup lids, espresso coffee maker and weldless fitting for brewing co2 o ring
  • [Application] - Widely used for Hydraulics and Pneumatics sealing, pressure valve, gas compressor, reaction valve, heat exchanger, boiler, filter, mechanical



Product Description

VMQ O-Ring

  • Hardness: 50A
  • Temperature: -22℉ (-30℃) to 392℉ (200℃)
1

Circular Cross-Section

  • They are circular in shape, round in cross-section.
  • Designed for use in a wide variety of sealing applications.
  • Commonly provide a pressure and fluid seal between cylindrically shaped, overlapping mating surfaces and are commonly seen in engines, faucets, flanges, valves, and various cylinders.

Silicone Rubber O-Ring

  • Noted for their ability to be used over a wide temperature range and for excellent resistance to ozone, weathering, and aging.
  • Standard silicones are resistant to water (to 100°C), aliphatic engine and transmission oils and animal and plant oils, and fats.
  • Silicones are generally not resistant to fuels, aromatic mineral oils, steam (short term to 120°C is possible), silicone oils and greases, acids, or alkalis.

Wide Applications

1

Plumbing

1

Gas Cylinder

1

Pneumatics

1

russell
Reviewed in the United States on September 22, 2024
Quality
Tom
Reviewed in Canada on December 29, 2024
To small for Co2 Cartridges
Airgun Junky
Reviewed in the United States on April 9, 2024
Red o rings sized perfect fit. Good seal too.
nam
Reviewed in Australia on July 28, 2023
i dont know anything about o ring i only brought this to mod my keyboard and it works prety good
alo892357
Reviewed in the United States on May 5, 2022
I bought these o-rings to use for a high temperature project and they deformed/melted. Bought these because they seemed similar to the silicone o-rings I normally get from McMaster-Carr. I'm not sure if these are actually silicone.. they should have at most became brittle and broke apart.
Subhanshu Pyne
Reviewed in the United States on May 1, 2022
DISCLAIMER: THE SCREWS THAT CAME WITH MY TOFU65 KIT FROM KBDFANS WERE NOT LONG ENOUGH TO DO THIS MOD. I HAD TO PICK UP A SEPARATE SET OF SCREWS.So yeah, if you have a Tofu65 and want to improve the sound profile of the board, I can't recommend this mod enough. If you're not sure what I'm talking about, look up Keybored's video on Youtube.
Customer
Reviewed in Canada on October 8, 2022
These didn't end up working out for what I had originally intended, but otherwise they're fine. Found they frayed and broke apart a bit easier than I would have liked, but that could just come down to the type of material.