Your cart is empty.
Your cart is empty. How to make sure whether the control box fits your car?
Open your broken electric ride on car and check the control box.
If the appearance of the control box is the same, this part should fit your car.
Ⅰ. The first use (or replace the battery) need to matching frequency Step 1. Install two AAA 1.5V batteries, (note the positive and negative polarity inside the battery chamber), and finally close the battery cover, indicator will flash three times indicates that the battery is installed correctly.
Step 2. Press and hold the frequency key(car select) for about 2 seconds and the indicator will flash
Step 3. Turn on the power supply of the car and the indicator will turn off
Step 4. If the matching frequency is unsuccessful (indicator not turn off), please turn off the power supply and repeat steps 2 and 3.
Specifications:
- Brand: weelye
- Model Number: RX19
- Voltage: 12V
Dean
Reviewed in Australia on May 26, 2023
The products turned up quickly, but when I installed it the buggy will only go backwards. If the selector is in Forward or Reverse it will go backwards. If controlled by the remote it works fine. I’ve checked the selector and it all tests fine.
Pelchat Joel
Reviewed in Canada on October 3, 2023
Ça n’a pas fonctionné pour moi
Jere
Reviewed in the United States on June 3, 2021
Working perfectly!
johan
Reviewed in the United States on May 8, 2021
Llego con una semana de anticipacion y en buen estado.
Bnflette
Reviewed in the United States on February 15, 2021
I was able to get my daughters little car working again after many hours and effort however it’s not the same quality as a control that came with the car. Rather than joysticks it has buttons and when you turn the car either direction with a button the wheels Don’t Center themselves automatically when you release the button. The only move backCorrect you correct it by pushing the button for the opposite direction Opposite button.
Richard Banks
Reviewed in the United States on May 18, 2020
I had to do some digging for a wiring diagram because it didn't come with one. Specifically, i wanted to know the pinouts on the 7 pin connector. Still not 100% on the speed selection though. The remote has 3 speed settings but the pinout only allows for hi and low speed. With the hi/low speed wire connected, it'll only give output at top speed when the remote is on, otherwise the speed will drop to low when the kids are depressing the accelerator pedal. I just disconnected the speed selector wire and it just stays in high speed mode.
Recommended Products
