Your cart is empty.
Your cart is empty. Model Number:310-7578 2400MP
Application:Commercial,Engineering,Indoor,Professional,Sailing
Wattage:260W
Type:Bare Lamp with housing
Average Life (hrs):2000
Place of Origin: Shenzhen, China (Mainland)
Be used in projectors: Dell 2400MP
9 Steps to replace the projector lamp
1.Gather the necessary tools, screwdriver.
2.Turn off TV or Projector.
3.Remove Lamp Compartment Door.
4.Remove Lamp Assembly. Carefully pull out the lamp assembly and disconnect any power cords that may still be connected to the lamp assembly. Put it aside and don't get it confused with your new lamp!
5.Clean Lamp Compartment. Dust gets everywhere and while you have the projector open, use a soft cloth or micro-fiber cleaning cloth to remove any loose dust from the lamp compartment.
6.Insert New Lamp Assembly. Carefully reconnect any power cables to the new lamp if present and slide the new lamp into the compartment in the same orientation that the original lamp came out.
7.Replace Lamp Compartment Door. Set the lamp compartment door back into place and securely screw in the door without screwing it in too tightly.
8.Reset the lamp timer. Instructions on how to do this should be covered by the instruction manual.
9.You're Done! Enjoy your projector or TV again and make sure you have a backup lamp handy in case the lights go out unexpectedly.
Clifford Hepler
Reviewed in the United States on July 26, 2019
Not very bright at all. Have to turn brightness up every time projector is turned on, and still isnt as bright as OEM bulb was
LARRY BLEVINS
Reviewed in the United States on January 8, 2019
Exactly what I needed.
Recommended Products
$41.75
$ 21 .59 $21.59