Your cart is empty.
Your cart is empty.This fully threaded rod is made of 18-8 stainless steel for corrosion resistance, has 3/8"-16 right-hand threads, and is 36" long.Threaded rods and studs are fasteners that screw into threaded nuts or tapped holes, allowing for assembly of components. The difference between rods and studs is length: In general, a stud is up to 1 foot long, and a rod is more than 1 foot long. Both have threads along part or all of their length. Those that are partially threaded have equal or unequal thread lengths on one or both ends. Studs are also available with a perforated base, weld projections, or a press-in captive head for securing to the surface of a component.
Paul Smith
Reviewed in Canada on July 12, 2024
Perfect for the Marine application I used it on.
IHeartArt
Reviewed in the United States on February 22, 2024
I needed 2 24" rods for a 3D printer modification but ended up buying 2 of this one simply because it was a fraction of the cost. Used my trusty hack saw and cut them down to size. The hex nuts I bought here are Amazon screwed on easily. This worked perfectly to stabilize my z axis. I highly recommend this rod.The packaging was pretty impressive as well, item arrived without it being bent.
conrad woll
Reviewed in Canada on December 10, 2024
like it using it for my boat
I'm Worth It
Reviewed in the United States on April 17, 2024
I am absolutely impressed with the quality and value of this threaded rod. It worked perfectly for my application. Limitless possible uses. Highly recommend.
Cliff
Reviewed in the United States on November 30, 2023
A good value.
rkruz
Reviewed in the United States on September 13, 2022
The threads were excellent across its entire length. No burrs or dents from handling. The ends had no damage and nuts screwed on perfectly. I cut it to length for my needs with a hacksaw. After a couple of months (Inside) there is no rust evident even on the cut ends.An excellent product!
the reviewer
Reviewed in the United States on December 21, 2022
18-8 thread, stainless steel rod. Wow this is much better quality than I was expecting. I tend to use a bit of stainless steel for my projects. Have blades for my reciprocating saw ( Saws All ) designed to cut Stainless steel. This rod is such high quality, when cutting to length for my project, it took two of those blades to cut through the threaded rod ( not unusual when dealing with the good stuff ).The threads are cut from end to end. Ends are machined smooth. Threads are true to size. No slop in nuts, as if cut if between SAE and Metric, these are EXACTLY cut to 18-8 nice and tight.Had a piece left over. Tried to bend it. Took some effort. Rod bent, did not break. Wow ... over kill for my project. Thinking will last well over 100 yrs. Threads will stay clean and completely usable.NOTE *** with Stainless steel, the edges of threads may gall ( bend over ), use milk of magnesium ( yes same stuff one might use for upset stomach) , or anti sieze, on your threads, bolts and nuts. Turn the bolts slowly and make sure are not cross threading. This is with EVERY stainless steel bolt, screw, nuts.If threads ( ramps ) on bolt gall, they will cause the nut to bind, maybe midway to being fully tightened, especially with low grade stainless steel products from Big Box hardware stores. Use a dry lube or anti seize .. look on line for more info.
Recommended Products
