Shopping Cart

Your cart is empty.

Your cart is empty.

214 Buna-N O-Ring, 90A Durometer, Round, Black, 1' ID, 1-1/4' OD, 1/8' Width (Pack of 50)

Free shipping on orders over CA $49.99

CA $11.38

CA $ 5 .99 CA $5.99

In Stock

About this item

  • Made of Buna-nitrile (also called Buna-N) for use with a variety of fluids from petroleum to aliphatic hydrocarbons
  • Durometer (hardness) of 90A for resistance to penetration
  • Round cross-section to provide a seal between cylindrical overlapping surfaces
  • For use across a wide temperature range from-30 degrees F/-34 degrees C to 250 degrees F/121 degrees C
  • Meets standards defined by Aerospace Standard AS568A


This O-ring is made of black Buna-nitrile (Buna-N) and has a durometer of 90A. It has a round cross-section and can be used across a wide temperature range (-30 degrees F/-34 degrees C to 250 degrees F/121 degrees C). Designed for use in a wide variety of sealing applications, this Buna-nitrile O-ring meet standards defined by Aerospace Standard AS568A, which is the Aerospace Size Standard for O-rings. Buna-nitrile can have high tensile strength, and has abrasion, tear, and compression set resistance. It is compatible for use with petroleum, hexafluoroacetone (HFA), hexafluoro-2-butyne (HFB) and hydrofluorocarbon (HFC) fluids, vegetable oil, alcohol, acids, and aliphatic hydrocarbons. Buna-nitrile is vulnerable to acetone, ethers, esters, ozone, sunlight and weathering, and should not be used in ozone-generating electric motors, welding equipment, or in applications with exposure to UV light. The durometer hardness of this Buna O-ring is 90A. Durometers measure the hardness of a material and its resistance to permanent indentation. A higher durometer value indicates greater resistance to indentation. On a scale of 0 to 100, a value of 0 indicates that a sample was completely penetrated, while a value of 100 shows no indentation in the sample. The letter following the number identifies the shore scale, which is either shore A or D. Shore A is used for softer plastics, while shore D is used for harder plastics. O-rings provide a pressure and fluid seal between cylindrically shaped, overlapping mating surfaces and are commonly seen in engines, faucets, flanges, valves, and various cylinders. They are circular in shape, with a round cross section, and a hole in the center, similar to a doughnut. O-rings are available in various AS568A dash sizes, which is the standardized sizing for O-rings, and defines the nominal inside diameter (ID), outer diameter (OD), and cross-sectional (CS) diameter of an O-ring.


Jessica Cannon
Reviewed in the United States on August 25, 2024
Sizes are not accurate, totally useless to me
Andrei
Reviewed in Canada on January 6, 2024
Perfect replacement for Clack WS1 bypass valve. With the amount of o rings in the bag, you may swap the rings monthly for the next 4 years and still have spares left.
William Joseph
Reviewed in the United States on July 12, 2021
These are not packs of 50 as advertised. All packs I have ordered came with 35
Recommended Products