Your cart is empty.
Your cart is empty.Product Description
Without insulation VS Insulated with thermal insulation wool
Without insulation VS Insulated with thermal insulation wool
First Step
Remove the screws on the underside of the 3D printer board.
Second Step
Tear off the 3D printer's isolation pad.
Third Step
Tear off the 3D printer's isolation pad.
Fourth Step
After pasting, reinstall the screws you can use.
Richard
Reviewed in Belgium on February 5, 2025
ok
Sascha Fischer
Reviewed in Germany on July 23, 2024
Lässt sich gut schneiden und klebt sehr gut. Damit hält der 3D Drucker sehr gut die Temperatur.
N
Reviewed in Canada on July 1, 2024
Good
Samantha A Tanner
Reviewed in Canada on April 25, 2024
I have an older 12 volt 3d printer. This insulation made all the difference. When printing low temp filaments like pla I didn't notice what I was missing. But I started using petg and abs and needed the much higher bed temps and it took seemingly forever to heat up. Yes 12 volt bed. This shaved so much time off the warm-up. Went from almost ten minutes to 90 degrees versus seven minutes. Also, not using a heated chamber yet as that would surely help. Item was quite crinkled as was described, but installs fine and the adhesive has remained in place over a dozen heat up and cool down cycles.
Drew Browne
Reviewed in Australia on July 26, 2023
You get what you order
Justin Perreault
Reviewed in Canada on November 7, 2023
very flat. needs glue stick to really adhere or prints will likely warp or come off
Marc-Andre
Reviewed in Canada on January 31, 2023
Nice upgrade for the creality ender 3 , prints are easier to remove off the bed
hutteman
Reviewed in the Netherlands on April 4, 2023
Het is een leuke hobby
Gabe
Reviewed in France on April 26, 2023
L'épaisseur de l'isolant fait que ça bute contre le moteur arrière de l'axe Y lors d'un retour arrière donc attention aux réglages de hauteur de plateau. Ca reste un bon produit et l'utilisation en est pertinente. Installé sur Creality ender 3.
Mykola
Reviewed in Canada on August 21, 2022
Great quality glass platform.Only used it with PLA so far. Adhesion is really good with parts releasing after cools down. I just give it a wipe with isopropyl alcohol ad it works perfectly.
John S.
Reviewed in Canada on May 23, 2022
Went from not being able to heat my whole extended heatbed. To it working perfectly. Worth every penny. Definitely buying again..
Mike Kessler
Reviewed in Canada on April 2, 2022
Easy to install. Seems to help spread the heat evenly. The heater cycles less often. No hot spots.
Recommended Products