Shopping Cart

Your cart is empty.

Your cart is empty.

DRV8833 Motor Drive Module 1.5A Dual H Bridge DC Gear Motor Driver Controller Board 4pcs

5.0 (1) Write Review
Free shipping on orders over $29.99

$7.19

$ 3 .59 $3.59

In Stock
  • DRV8833 2 Channel Motor Driver Module 1.5A 3V-10V H-Bridge 4-Wire Step Motor
  • Single H bridge output current: 1.5A, can drive 2 DC geared motors.
  • Built-in overcurrent protection, short circuit protection, undervoltage lockout and overtemperature protection. With low power sleep mode.
  • For DIY smart car robot, it can drive DC motors up to 1.5A and 4-wire stepper motors.
  • Input voltage: 3-10V，Size: 18.5*16mm


Product parameters:
Size: 18.5*16mm
Input voltage: 3 - 10V
Single H bridge output current: 1.5A, can drive 2 DC geared motors.
Built-in overcurrent protection, short circuit protection, undervoltage lockout and overtemperature protection. With low power sleep mode.
Uses:It can drive DC motors up to 1.5A and 4-wire stepper motors.
Instructions for use:
ULT low level is sleep mode (need to disconnect the J2 short solder joint behind the module)
OUT1, 0UT2 is a 1-way H-bridge, and the corresponding control is IN1, IN2.
OUT3, 0UT4 is the second H-bridge, and the corresponding control is IN3, IN4.
EEP is the protection output and is not used by default.
VCC is a voltage input of 3 to 10V.
GND is grounded.
Package Included:
4 x DRV8833 Motor Drive Module


CHeisler
Reviewed in Canada on October 19, 2024
Only tested one of four units in a pack but so far so good for running a small 6v motor