Shopping Cart

Your cart is empty.

Your cart is empty.

ESP32 LOLIN32 Lite MicroPython Version with Battery Charger

Free shipping on orders over $29.99

$6.12

$ 2 .87 $2.87

In Stock

About this item

  • Compatible With Arduino Wi-Fi + Bluetooth + BLE Module
  • 240MHz High Power Processor, 4MB Flash Memory
  • 3.3V Device with 19 GPIO Ports and 6 Analog Inputs
  • Integrated Lithium Charger Circuit max. 500mA
  • Please see MicroPython.org for the latest firmware version, and consider updating your module to take advantage of bug fixes and new features


This ESP32 based WEMOS Lolin32 Lite compatible WiFi enabled Development Board comes with MicroPython Firmware (Interpreter) installed. All you need to program it, is a USB or serial (RX/TX) connection to the host (computer) and a terminal program. Programming is a lot simpler than Arduino (based on C), and can be done without the need for a special development environment (like Arduino IDE or AVR Studio).

Specifications:
Power Supply: 2.2V to 3.6V
Logic Level: 3.3V
Processors:
– Xtensa 32-bit LX6 core, operating at 160 or 240 MHz and performing at up to 600 DMIPS
– Ultra low power (ULP) co-processor
Memory:
– 520kB SRAM
– 4MB Flash
Wireless connectivity:
– Wi-Fi: 802.11 b/g/n
– Bluetooth: v4.2 BR/EDR and BLE Peripheral interfaces*:
– 12-bit SAR ADC up to 18 channels
– 2 8-bit DACs
– 10 touch sensors (capacitive sensing GPIOs)
– Temperature sensor
– 4 SPI
– 2 IS interfaces
– 2 IC interfaces
– 3 UART
– SD/SDIO/CE-ATA/MMC/eMMC host controller
– SDIO/SPI slave controller
– Ethernet MAC interface with dedicated DMA and IEEE 1588 Precision Time Protocol support
– CAN bus 2.0
– Infrared remote controller (TX/RX, up to 8 channels)
– Motor PWM
– LED PWM (up to 16 channels)
– Hall effect sensor
– Ultra low power analog pre-amplifier
Security:
– IEEE 802.11 standard security features all supported, including WFA, WPA/WPA2 and WAPI
– Secure boot
– Flash encryption
– 1024-bit OTP, up to 768-bit for customers
– Cryptographic hardware acceleration: AES, SHA-2, RSA, elliptic curve cryptography (ECC), random number generator (RNG)
Power management:
– Internal low-dropout regulator
R


James B
Reviewed in Canada on December 19, 2021
This is a good ESP32 clone dev board that adds the ability to charge a LiPo battery as well as run off the battery; makes a great built-in UPS system for field-mounted sensors.
K. Stephens
Reviewed in the United States on November 24, 2020
It worked. I did not smoke it like the previous one I received. Hint: Don't hook up 3.3 volts while the USB is connected to your computer.
Recommended Products

$677.16

$ 71 .28 $71.28

4.8
Select Option

$1,108.29

$ 71 .28 $71.28

5.0
Select Option

$316.07

$ 71 .28 $71.28

4.8
Select Option

$344.87

$ 71 .28 $71.28

4.3
Select Option

$159.75

$ 71 .28 $71.28

4.6
Select Option

$249.93

$ 71 .28 $71.28

4.4
Select Option