Your cart is empty.
Your cart is empty.
Title: Third brake light
Application:
- 10" Recess Mount for Leer, ARE, Century, Jason and Astro
Color: Smoke Lens
Description:
- Placement on Vehicle: Rear
- Housing Color: Chrome (Crystal)
- Fitment Type: Direct Replacement
- Interchange Part Number: AT-LED-36R
- Voltage:13.8v DC nominal (9-15v DC)
- Amperage: 203 amps @ 13.8v DC
- Ratings & Approvals: S.A.E U 98
- Ultra slim lamp allowing creative design locations utilizing minimal cap space.
- Super bright LED's extend lamp life and reduce heat, while meeting S.A.E. ratings.
- One piece, high impact plastic polycarbonate lens assembly locks out moisture and resists discoloration.
- Bottom tape mounting assures that the lamp "stays put".
- 10" wide at the top and 9.5" wide at the bottom.
- Mounts with 3M tape which is already applied to the Light
Package Included
- 1 * Smoke Lens Third Brake Light
Notes:
This light contains 6 LED's. "AT-LED-36R" is the manufacturer part number, not an indication of how may LED's are in the light.
Bill
Reviewed in Canada on April 8, 2025
Fit my 2014 topper perfect. Water got behind the last one. Caulk the top and sides to prevent damage.
Robert Frew
Reviewed in Canada on June 14, 2024
Great fit in topper.
customer
Reviewed in Canada on November 12, 2024
Nice and bright
H. Kon
Reviewed in the United States on November 18, 2021
Nice lamp. A perfect fitting replacement for my faded, burnt out original lamp. Make sure you clean off all of the old adhesive tape residue and accumulated dirt and mold before you install the new one. You’ll need to have some exterior grade silicone caulk on hand to seal the wiring pass-through against water leaks. The pins on the wires snap into the harness connector housing once you’ve persuaded the old ones out. Nice and bright. Hope it lasts as long as the original one (14yrs)
P.B.
Reviewed in Canada on October 18, 2021
GREAT PRODUCT.
RQ
Reviewed in the United States on January 9, 2021
(2004 F150 ) Leer truck topper. upper rear break light replacement worked great, fit was good. Electrical pins were compatible with my existing wire harness. Nice and bright . Liking the fit, form and function. Cleaned up area for installation of new light and installed the light with no problems. Strong Adhesive backing, so make sure you clean and position your light accordingly, once installed its difficult to reposition.. I did seal it up with some clear RTV around where it mates to the topper just to ensure a water tight seal behind the light but that was my OCD working.
Thomas J Ouellette
Reviewed in the United States on April 30, 2021
Easy to install, fit perfectly. The double sided tape holds on solidly. There was a long pigtail which made connecting it to the vehicle easy. I temporarily used some spade terminals. I will be getting a getter connector and installing it. The long pigtail makes that not a concern. Also the lights are nice and bright.
Colin
Reviewed in the United States on February 2, 2020
Nice looking, bright enough, and direct replacement, exactly what I needed. Has condensation built up inside after less that two months on vehicle.
Ronald J. Sipko
Reviewed in the United States on December 16, 2020
I failed PA state inspection due to this "third" brake light failing on my Leer cap mounted on 2007 Tacoma.The replacement came fast. All LED's. It was easy to install and fit perfectly.Clean the area up real good. Slow down! Be careful with placing the adhesive. Once you are stuck...you are stuck!Good product. Works fine.
Recommended Products
$34.29
$ 17 .99 $17.99