Shopping Cart

Your cart is empty.

Your cart is empty.

Solar Boost SB2512iX-HV, 25A MPPT Solar Charge Controller for 12V Lead Acid Batteries. Auxiliary Output for Dual Battery Charge or 25A LVD Load Output

Free shipping on orders over $31.42

$164.46

$ 73 .92 $73.92

In Stock

About this item

  • MPPT BUCK charge controller for 12V-nominal Lead Acid battery, 25A with 36-cell panels up to 340W or 20A with 60-cell panel up to 270W
  • Max. recommended panel Voc 40V at STC (max input voltage 50V). Auxiliary Output programmed for max 25A with LVD or for 2A maintaining of a secondary battery
  • Advanced Multi-Stage charge profile plus equalization. Programmable for custom settings or Lithium batteries with IPN ProRemote display (ASIN: B01GW3UPV2) or ProTouch (ASIN: B0BHQVYS19)
  • Surface or Flush Wall mounting, ideal for RVs and Marine. IPN capability network interface coordinates up to 8 controllers (Master/Followers)
  • 5-Year Warranty, Made in USA, CE/FCC/RoHS certifications. Datasheet in the “Technical Specification” below


Overview
The SB2512iX-HV(-Li) features our patented MPPT technology, a second auxiliary battery output, and IPN connector for remote display, which is ideal for RVs and Marine. The SB2512iX-HV(-Li), can manage a 25A DC Load Output and with an IPN ProRemote, BT Connect, or UCM, the DC Load Output is fully programmed. The
SB2512iX-HV, is programmed for Lead Acid batteries while the SB2512iX-HV-Li is programmed for charging 4S LiFePO4 batteries. Both versions can be programmed with a remote display, UCM, or BT Connect for a custom charge profile for any type of battery.
Features:
- MPPT BUCK technology
- Surface or Flush mounting
- DC Output Load with Low Voltage Disconnect (LVD)
- Battery temperature compensation with battery temp. sensor ASIN: B007S3HWDA (for version SB2512iX-HV)
- Fully programmable by remote display IPN ProRemote (ASIN: B0BJ28ZFTS) or ProTouch (ASIN: B0BHQVYS19)
- Made in the USA
- 5-Year Warranty
Specifications:
- Max. Recommended Panel Power: 340W (36-cell panel) or 270W (60-cell panel)
- Rated Battery (Output) Current: 25A (36-cell panel) or 20A (60-cell panel)
- Max Panel Voltage: 50V
- Max Recommended Panel Voc @ STC 40V
- Operating Temp. Range: -40°C - 45°C
- Battery/Panel Connections: 4-position terminal block for 10-20 AWG wire
- Dimensions: 5.3x5.3x2.5"
- Certifications: CE, FCC, RoHS
SB2512iX-HV:
- Battery Type: 12V Lead Acid
- Absorption Voltage: 14.2V
- Float Voltage: 13.2V
- Equalization Voltage: 15.2V (if enabled)
- Load (LVD) Disconnect/Reconnect Voltage: 11.5 V / 12.6 V
SB2512iX-HV-Li:
- Battery Type: 4S Lithium LiFePO4
- Absorption Voltage: 14.4V
- Float Voltage: 13.6V
- Absorption Time: 0.5 Hr
- Load (LVD) Disconnect/Reconnect Voltage: 11.0 V / 12.0 V


Dennis
Reviewed in the United States on June 19, 2024
I bought this to replace the original I got used in 2015. It started overcharging my battery. So bought a replacement, exactly like the original made in 2012.
Kindle Customer
Reviewed in the United States on June 4, 2021
All I know is this unit worked when my old one did not. This was a one for one replacement. I’ve been using the Blue Sky Charge Controller for many years now without a problem until my Inverter/Charging unit in the motorhome burned up and cost me 4 new batteries.
Gilles Girard
Reviewed in Canada on August 30, 2020
very fast shipping
Peter Henry
Reviewed in the United States on June 24, 2014
I've used one of these with the remote display on my boat's solar system for a couple of years. It is a solid and efficient MPPT charger that consistently gives me about 20% extra charging current than I would get with a straight charger. It starts being a positive contributor to the charge output when the solar is delivering more than about 1.5A - not hard to do. Below that, the extra overhead of the MPPT switching actually decreases your output current slightly.My comments will be about the system with the remote unit - the remote makes programming this super easy and gives great information. Multiple 2512 controllers can be put in parallel to allow higher-power systems, and I am adding a second unit in now as I increase my solar capability.The unit has a tremendous amount of programming capability to allow it to work with virtually any battery type. It has a secondary output that can be used either as a switched output such as a light control, or a low-power "top-off" for an additional battery. In my system, I have a 500A-H house battery bank and a separate starter battery. The secondary output keeps my starting battery charger nicely.The entire unit is a metal heat sink for the controller. It's easy to mount, but needs to be in a dry area since there is no waterproofing. It has good efficiency on the power conversion, so the case stays at very reasonable temperatures.I've specifically investigated whether this unit is creating much noise on my SSB radio, and have been happy to find that it does not. I installed a switch on the solar side to kill off any large switching transients just in case, but find that I don't use it.I'd give it 5-stars if it was better protected for marine use.
DawgTchrr
Reviewed in the United States on December 14, 2014
after purchase I should have looked for larger unit, 20-25 amps isn't much.
Erik in MN
Reviewed in the United States on October 14, 2013
Great charger/Controller. It Fits in a standard 11B electrical box, a little tight but the compact form makes it easy to Install anywhere. I've only got hundred watts or about 5 A going through it and it handles it just fine.
Recommended Products