Shopping Cart

Your cart is empty.

Your cart is empty.

EPEVER MT-1 Remote Meter with LCD Display for Duo Battery Solar Panel Charge Controller

Free shipping on orders over $29.99

$42.47

$ 21 .59 $21.59

In Stock

1.ColourName:Epipdb-com-10a


About this item

  • EPEVER MT-1 Remote Meter with LCD Display for 10A/20A Dual Battery Solar Panel Charge Controller.
  • Shows you the main charging parameters and information about performance of your solar system, such as voltage, current and state of charge of your batteries.
  • Battery charge / accumulated capacity / min and max voltage can be recorded which is great for comparing performance of the system at different periods.
  • Temperature and time can also be displayed on the screen. The meter can be set to go through each data parameter and change every 3 seconds or display only the chosen set of data. 4 buttons on the front side allow you to switch between data sets easily.
  • The meter is supplied with 10m connection cable, which can be easily plugged into your dual battery solar charge controller.



Product Description

DB

  • This dual battery solar charge controller is designed for independent charging of 2x12V or 2x24V batteries / battery banks.
  • The controller uses PWM (Pulse Width Modulation) technology which increases charge acceptance and extends the life of your batteries. PWM technology can also recover some lost battery capacity.
  • Initial charging priority can be set e.g. 80% of power to the engine battery and 20% to leisure battery. When one of the batteries is fully charged the controller will automatically divert all power to the other battery.
DB

  • Solar System: 12V/24V Auto recognition
  • Maximum solar voltage: 30V(12V System)/ 55V(24V System)
  • Battery voltage range: 8~15V
  • Boost time: 120 minutes
  • Self-consumption: 4mA at night, 10mA at charging
  • Meterbus connection: 8- PIN RJ-45
  • Temp. Compensation: -5mV/℃/2V
  • Terminals: 4mm2
  • Temperature: -35℃ ~ +55℃
MT-1

  • Rated voltage: 12V
  • Min voltage (suggest): 8.0V
  • Backlight and LED indicator off: <17mA
  • Operation temperature: -40℃ ~ +60℃
  • Communication cable: RJ45 (8PIN), 10 meter
  • EPEVER MT-1 Remote Meter with LCD Display for 10A/20A Dual Battery Solar Panel Charge Controller
  • Battery charge / accumulated capacity / min and max voltage can be recorded which is great for comparing performance of the system at different periods
DB

  • Over load protection, Short circuit protection, Reverse polarity protection, Over charging or discharging protection, Reverse current protection during night
  • Three leds flashing, each LED express different specifications, choose the 3 LED first according to the following information, and then press the switch for 5 seconds until the number flashing, choose one number as you need, and leave it and the number you set will be saved
  • Note: all the data is for 12V, for 24V, please use 2x
DB

  • Fit for motorhome, caravan, boat or any system with two 12V/24V batteries or battery banks

john s. shikoluk
Reviewed in the United States on January 9, 2025
Nice controller easy to install and set up, works as it should.
Todd O'Briant
Reviewed in the United States on September 19, 2024
Install on my Houseboat works good so far
Guillermo
Reviewed in the United States on December 17, 2024
El producto cumplió mis expectativas
Jay
Reviewed in the United States on August 30, 2023
I have a dual battery, single solar panel setup on my camper. This will charge each battery individually and monitor each battery individually. It’s awesome for the price and the remote is a must. I ran the remote inside so I can keep tabs on what the system is doing and how much power o have available.
Dave
Reviewed in the United States on July 19, 2020
Works as intended. Instructions are brief but if you’re installing your own solar system you can probably figure it out.
Recommended Products

$35.99

$ 15 .83 $15.83

4.6
Select Option