Your cart is empty.
Your cart is empty.The ECGB series of ground bars are intended for use on Siemens EQ and Ultimate brand of load centers. Load centers would include all catalog numbers that begin with an E, W, or G. The ground bars can also be used on small circuit Murray load centers which would include all 4 and 8 space, 125A load centers.
Christopher Matthews
Reviewed in the United States on April 16, 2023
Great
Ken P.
Reviewed in the United States on March 12, 2022
The picture I've provided is NOT the Ground Bar, but rather the reason I bought this one.The Talon panel I used had a short, tiny 6 or 7 space ground bar that was inadequate for future capability. This new bar gives me the couple extra spaces I'll require at a later date.FJB
DH
Reviewed in the United States on November 28, 2021
Found out when getting my main panel replaced that this sub panel had the grounds and neutrals together. Electricians mentioned they should be separate after main. Ordered this and it fit perfect. Was able to add myself since I could shut the power off to the sub panel from the main. Was it absolutely needed? Not sure, but for the cost and ease of install vs leaving it wired as it was, why not.
TJohns
Reviewed in the United States on November 20, 2021
Preformed and fit as expected
Lakewalker
Reviewed in the United States on November 27, 2020
These are a necessary evil. You spend a couple hundred on a 30 circuit panel and it doesn't have nearly enough ground slots. You either add these or put 2 wires in 1 hole and risk the inspector failing it. At first I didn't think it would fit. The pre-drilled holes in the panel are slightly offset and oversized for the provided screws. You push the first screw by hand. When you screw in the second one, the offset presses the first screw against the side of the hole, binding it in place.
Recommended Products
