Shopping Cart

Your cart is empty.

Your cart is empty.

DAOKI 5Pcs Microphone Amplifier Module MAX4466 Electret Microphone Amplifier GY-MAX4466 Breakout Sensor, with Adjustable Gain Breakout Board for Arduino

Free shipping on orders over $29.99

$10.79

$ 5 .75 $5.75

In Stock
  • The board comes with a 20-20KHz electret microphone soldered on
  • Using the MAX4466, an op-amp specifically designed for amplifier
  • For the best performance, use the "quietest" supply available (on an for Arduino, this would be the 3.3V supply)
  • The amplifier has excellent power supply noise rejection
  • This breakout board is best used for projects such as voice changers, audio recordingmpling, and audio-reactive projects that use FFT


Description:
The MAX4466 is a micro power operational amplifier optimized for use as a microphone preamplifier. Add an ear to your project with this well-designed which has excellent power supply noise rejection.
On the back, we include a small trimmer pot to adjust the gain. You can set the gain from 25x to 125x. That's down to be about 200mVpp (for normal speaking volume about 6" away).

Using introduction:
Connect GND to ground, VCC to 2.4-5VDC.
The audio waveform will come out of the OUT pin.
The output will have a DC bias of VCC/2 so when it’s perfectly quiet, the voltage will be a steady VCC/2 volts (it is DC coupled).
If the audio equipment you're using requires AC coupled audio, place a 100uF capacitor between the output pin and the input of your device.
If you're connecting to an audio amplifier that has differential inputs or includes decoupling capacitors, the 100uF cap is not required.

Features and benefits:
Power supply voltage: + 2.4V to + 5.5V (can be directly connected to STM / ARDUNIO / Raspberry Pi and other development board)
Power supply rejection ratio: 112dB
Common mode rejection ratio: 126dB
AVOL: 125dB (RL = 100kΩ) rail-to-rail output
Static supply current: andlt;24μA
Gain bandwidth: 600kHz
Size: 20.8mm x 13.8mm x 7.5mm/0.8 x 0.5 x 0.3inch

Applications:
Cellular phone
Digital repeater
Headphones
Hearing aids
Microphone preamplifier
Portable computer
Speech recognition system

Package included:
5 x MAX4466 Electret Microphone Amplifier Module
5 x 3pin
1 x 15pin DuPont Wire Female to Male


Claude Everton
Reviewed in Canada on March 13, 2024
Nice small package that works very well. Can be fitted inside most microphones. I removed the electret from the board and added this board to an existing microphone which had a defective preamp. Works great!
Martin
Reviewed in Canada on November 11, 2024
Conforme à la description
River Liu
Reviewed in Canada on September 2, 2022
easy to be damaged, only 1pcs was working after 2 weeks.anyway it is quite sensitive and high quality.