Your cart is empty.
Your cart is empty.Rob
Reviewed in Canada on March 6, 2025
Work great. I stacked both seals to effect a good seal around the entire light. Lost a star due to no instructions. But it does the job
Galen
Reviewed in the United States on March 27, 2025
Right thing worked great and send extra for later on have a extra fit perfect.
dexter robinson
Reviewed in the United States on March 26, 2025
took care of my water leaking from brake light
mike v
Reviewed in the United States on February 28, 2025
I had this constant leak, water kept dripping from the seatbelt and the driver back side, replaced the seal on the break light and no more water
Bob Mann
Reviewed in the United States on January 13, 2025
It is a proper gasket for my third brake light.
Daniel Murray
Reviewed in the United States on September 11, 2024
I replaced my 3rd brake light bulb and had a leak in rain storm right after. Brought this new seal kit and no more leak. WooHoo
Bernie
Reviewed in Canada on August 16, 2024
Dodge ram truck
Rick
Reviewed in Canada on May 17, 2024
Very nice product , and surprised to find 2 gaskets in package
Joselyn Rimell
Reviewed in Canada on September 12, 2023
So a couple of thoughts to share. First, shame on Dodge for the shitty design. Should be recalled.Anyway, I used a dull putty knife to remove the old seal, so I wouldnt damage where the seal sits. Then used glue remover to remove, well, the glue (Würth adhesive remover). Then rubbing alcohol to prep for the new seal. When placing the new seal on, be sure to place it at the top of the seat. I placed the first one too low and had to use the second seal to correct the mistake. Good thing it comes with two! Cleaned the dirt off the truck and reinstalled the seal. Because the light has bent with the heat of the sun, or the pressure of the end screws the seal isn't super tight. Certainly tighter than the old one, and I pretty sure it will keep out water, but ultimately I think the solution is to replace the light every 8-10 years. 😞 Also, hard to test without removing the headliner.
Eddy
Reviewed in Canada on August 13, 2023
Installed on my 2016 Ram. This solved the leak coming from the passenger roof. Very satisfied.
Grimm
Reviewed in Canada on June 2, 2023
Used on my 2012 Dodge Ram Laramie 2500Fit was bang on, thick enough to get a good seal all the way around. Used the supplied wipe and cleaned the painted edges of the truck “not the third break light” Screwed back on while pressing the light tight towards the new gasket and 👌
Wayne
Reviewed in Canada on March 7, 2021
This item worked without any trouble to install
Bill
Reviewed in Canada on December 30, 2021
Appear to be of good quality - peel off sticky side, good density and even cut. Comes with alcohol swab, presumably for cleaning surface after removing old gasket. I'm dreading the removal based on the experience of others reported online. Given the high frequency of leaks with rear cab lights, I'm considering applying a thin layer of butyl tape in addition to this gasket. Best practice for this sort of thing is to avoid using silicone otherwise future removal (and perhaps increased risk of failure) will be challenging.
Recommended Products
